Attero Tech AXON D2FLEXio Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Aufnahmegeräte Attero Tech AXON D2FLEXio herunter. Attero Tech AXON D2FLEXio 11 Seiten. Dual analog flex i/o networked audio interface

Seite drucken

– Device Configuration

There are two parts of the device that require setup. First the

audio routing, and second the configurable features of the device

itself.

The audio routing should be carried out using any application

that supports Dante™ audio routing. This could be from a 3rd

party manufacturer or be Audinate's Dante Controller software.

Dante™ Controller can be obtained from the Audinate website

(www.Audinate.com). Instructions on how to use this software

and about setting up routes on a Dante™ network can also be

found on Audinate's website.

*Note:

When using Dante™ Controller, the D2FLEXio will be

shown using a default device name of D2FLEXio-###### where

'######' is the last six characters of the devices MAC address.

3.1 – Audio Configuration

Based on the I/O mode selected the device can be configured with

two options.

Figure 9 - I/O configuration pots

3.1.1 – Input Settings

The line-level input pads are adjusted using 2 rotary pots. A small

screwdriver is needed to adjust the input pad levels. The inputs

have an adjustable attenuation range of 0 to -24dB, allowing an

input full scale input signal range of 0 dBu to +24 dBu.

3.1.2 – Output Settings

The output gains are adjusted using 2 rotary pots. A small

screwdriver is needed to adjust the gain levels. The outputs have

an adjustable gain range of 0 to +24dB, allowing for full scale

output levels of 0 dBu to +24 dBu.

1315 Directors Row Suite 107 Fort Wayne, IN 46808 ⁞ (260)496-9668 ⁞ www.atterotech.com

3.2– IP Address Setup

************************* IMPORTANT **************************

Failure to correctly configure IP addresses will not allow an

D2FLEXio device to correctly authenticate in the unIFY Control

Panel software and while it will show up in Dante Controller, the

input and output channels won't be visible and routing of audio

to and from the D2FLEXio will not be possible.

*******************************************************************

In order to configure a D2FLEXio both set up audio routing and

to update firmware, the PC will need to be able to communicate

with it over the network. While all Dante™/AES67 devices will be

discovered regardless of the IP address setup on the PC,

communication can only occur if the PC and the device have

compatible IP addresses.

By default, D2FLEXio is set to get a dynamic IP address. As with

all Dante™/AES67 devices, if the D2FLEXio device does not find a

DHCP server to retrieve an IP address from, it will give itself an

automatic private IP address (APIPA) instead. An APIPA is always

in the range 169.254.x.y.

To ensure communication, the PC can either be set to get a

dynamic IP address, or be given a static IP address in the range

169.254.x.y. The PC may require a restart for the changes to take

effect.

Further information on IP setup for an audio system using Dante

can

found

the

(https://www.audinate.com/resources/faqs).

FAQ's

the

Audinate

website

Page 5