3onedata IES205G Handbuch zur Schnellinstallation - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Schalter 3onedata IES205G herunter. 3onedata IES205G 2 Seiten. Unmanaged industrial ethernet switch

Seite drucken
Step 1
Check whether the DIN-Rail mounting kit that
comes with the device is installed firmly.
Step 2
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the product is firmly installed on
DIN-Rail, and then mounting ends.
【Disassembling DIN-Rail】
Step 1
Power off the device.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, and then shift out the
bottom of DIN-Rail, disassembling ends.
Attention before powering on:
Power ON operation: first connect power line to the
connection terminal of device power supply, and then
power on.
Power OFF operation: first unpin the power plug, and
then remove the power line, please note the operation
order above.
【Power Supply Connection】
DC power supply
The product provides 3 pins power supply
input terminal blocks with DC power input.
The power supply supports nonpolarity
and anti-reverse connection. It can
normally operate after reverse connection. Power supply
range: 12～48VDC. Pins definition of power supply as follows:
Pin NO.
1
2
Pins Definition
V-
FG
【Checking LED Indicator】
The function of each LED is described in the table as below:
LED
Status
Description
PWR
ON
PWR is connected and running
OFF
Link/
ON
ACT
Blinking
(G1-
OFF
G5)
【Specification】
Panel
Gigabit copper port
Indicator
Exchange attributes
Backplane bandwidth
Packet buffer size
MAC table size
Power supply
Input power supply
Access terminal
Consumption
No-load
Full-load
Environmental
Limits
Working temperature
3
V+
Storage temperature
Working humidity
Protection grade
normally
PWR is disconnected and running
abnormally.
Ethernet port connection is active.
Data transmitted
Ethernet port connection is inactive.
10/100/1000Base-T(X), flow
control, full/half duplex,
self-adapting operating mode,
support MDI/MDI-X self-adaption,
RJ45 port
Power indicator, interface
indicator
14G
1Mbit
8K
12~48VDC
Support nonpolarity and
anti-reverse connection
3 pins 7.62mm pitch terminal
blocks
0.86W@24VDC
4.63W@24VDC
-40~75℃
-40~85℃
5%~95% (no condensation)
IP40 (metal shell)