DT Research DT395 Grundlegendes Betriebshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Grundlegendes Betriebshandbuch für Tablette DT Research DT395 herunter. DT Research DT395 4 Seiten. Mobile pos tablet
Auch für DT Research DT395: Grundlegendes Betriebshandbuch (4 seiten)

Seite drucken

DT395

OPERATION

Internal Battery Switch

Warning!

The Internal battery pack should only be replaced by an authorized WebDT service

representative. Please contact your product and/or service provider for internal battery

replacement service.

Powering ON and OFF

To activate the DT395, push and quickly release the Power Button to the right side of the

front bezel. The display will come on in a few seconds. To put the DT395 in Standby

mode, push and quickly release the Power Button. To turn the W DT395 off for extended

storage, power off the device safely using any software function that "shuts down

computer" provided in the software operating system.

NOTE: The battery packs shipped with your device may be low in power—please use the

AC-DC adapter with the DT395 when setting up the device for the first time to fully

charge the internal battery pack. You may charge the external battery pack with it

attached to the DT395, or with the optional external battery charger kit.

NOTE: When the battery pack(s) is (are) charging, the blue-colored Battery LED should

blink slowly. If plugging in the AC-DC adapter does not trigger this blinking activity and

the LED stays dark, the battery pack(s) may have been drained substantially. Try

unplugging/ replugging the AC-DC adapter to the DT395 a few times to activate the

charging process.

NOTE: To conserve power, use (push and quick release) the Power Button to put the

device in "Standby" mode while not in use. Pushing briefly on the same button will wake

up the system within seconds.

NOTE: Avoid using the Power Button ("hold 4+ seconds" feature) to turn off the

device—this form of hardware shutdown is intended to be a means of recovery from

device lockups, and not as normal operation.

ENGLISH

Start Up

If the power up (from Standby or otherwise) is successful, the appropriate interface will

be displayed after a launch sequence of several seconds. The wireless LAN connection

may take 10-15 seconds to be established.

Configuring the DT395

The device may be configured using the utilities and methods dictated by the software

operating system. The DT395 should be configurable for various properties such as user

profiles, network features, and several system elements.

Calibration

The touch display for the DT395 is calibrated before shipping. In the event that the

calibration has been modified or is unsatisfactory, the respective calibration routines

(e.g., PenMount (PM) for Windows XP) to calibrate the touch interface may be used.

Such applications are typically executed through touch input via Stylus or through mouse

click via a USB mouse.

Wireless Networking

Wireless LAN

The DT395 is often delivered with an embedded (user-inaccessible) 802.11a/b/g/n

WLAN adapter equipped with a hidden custom antenna.

• Through the support of typical WLAN adapters, the DT395 should be able to detect all

802.11 access points in the vicinity for you to select the access point of your choice for

connection.

• The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT395 and the access

points have to match. The SSID is case-sensitive and it is recommended that you enable

WEP/WPA/WPA2 encryption (or advanced alternatives) for secure access.

• When WEP/WPA/WPA2 is enabled, you may need to consult your network

administrator or your networking equipment literature to properly configure associated

settings such as Authentication mode, etc.

• Refer to the access point operating manuals for setting up the 802.11 access points.

ENGLISH