DTAR Wave-Length Installationsanleitung Handbuch - Seite 14
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Messwertaufnehmer DTAR Wave-Length herunter. DTAR Wave-Length 16 Seiten. Under saddle transducer
Seite drucken
Installing the Optional Volume & Tone Module (Not Included)
4.
Route the V&T Module cable through the same slot as the
pickup cable. It is desirable to secure the cable to the inside
of the chassis with a small amount of hot glue.
5.
It may be useful to turn up the treble response of the preamp
slightly in order to allow more usable range of the external
tone control you will be installing.
6.
Replace the cover and secure the screws. Be sure to align
the holes with the trimpots.
7.
Install the Wave-Length system in the guitar according to
the instruction sheet included with the Wave-Length.
8.
Determine the proper location for the V&T Module by dry-
fitting it underneath the bass side of the soundhole. When
you have found a location that will give you comfortable
access to the controls, clean the area with alcohol to
remove any oils or sawdust.
9.
Remove the release liner of the double backed tape and
apply the module to the chosen location. If there is
excessive cable length, it should be secured using one
of the cable clamps included with the Wave-Length.
14
|
Installation Instructions