Boumatic Flo-Star Liner Cap Montageanleitung

Blättern Sie online oder laden Sie pdf Montageanleitung für Landwirtschaftliche Geräte Boumatic Flo-Star Liner Cap herunter. Boumatic Flo-Star Liner Cap 2 Seiten. Standard and light-weight visi-shell weights

Seite drucken

Flo-Star Liner Cap

Assembly Instructions for use with Standard

and Light-Weight Visi-Shell Weights

Introduction

The Bou-Matic

Flo-Star™ liner cap adapts the

Visi-Shell for use with the Flo-Star liner. The cap

must be assembled to the shell weight before the

liner can be assembled.

The information within this instruction packet is

intended to aid both the dealer and the dairyman in

the assembly of the Flo-Star liner cap and Visi-Shell

weight. Read the instructions carefully before

assembling and using the equipment to ensure proper

assembly.

The dairyman is responsible for maintaining and

monitoring the equipment to ensure that it functions

properly.

Figure 1. Position of cap, cone, and shell weight before assembly

Step 1

Place the shell weight, knurled end up, on a table or

workbench. Then, place the cone inside the weight, and

push the cap onto the cone, as shown in Figure 1.

Flo-Star Liner Cap Installation

Assembly Instructions

No tools are required for this cap and weight

assembly, however, the cup and cone (#8514062)

will ease assembly, and the teat cup assembler

(#8511810) along with the cap tool adapter

(#8514063, which includes 8514062) make assembly

easier. These tools are available from Bou-Matic.

To assemble the liner cap without tools, begin

stretching the small end of the cap over the knurl of

the shell weight. Hold this portion in place and work

your way around the weight until the cap completely

covers the knurl. (You may want to immerse the cap

in hot water to make it more pliable before assembly.)

To assemble the liner cap by hand using the cup and

cone, use the following procedure:

Figure 2. Cup used to push cap over cone and onto shell weight

Step 2

Place the cup over the cap, open end down, and push the

cap over the cone until the cap snaps over the shell

weight. (See Figure 2.)Then, pull the cone out of the cap.

The Dairy Equipment Div.

of DEC International, Inc.

PO Box 8050

Madison, WI 53708

608-222-3484

9P-576A