Bourgault PKG I2I CMPNT NA Installation und Einrichtung - Seite 3

Blättern Sie online oder laden Sie pdf Installation und Einrichtung für Sämaschinen Bourgault PKG I2I CMPNT NA herunter. Bourgault PKG I2I CMPNT NA 14 Seiten. Air seeders

Seite drucken

Instructions

1 I2I (M2M) Coverage Sharing

This feature allows you to share coverage between

multiple implements operating in the same field

to allow the ASC feature to turn off the product

application and raise the implement over areas

where other implements have seeded already.

1.1

Installation of I2I components

1.1.1

Antenna Installation

1. Mount the antenna on the tractor roof facing

forward so it can break away if it contacts an

obstacle.

2. Use supplied washers as required to space the

base plate away from the roof panel.

3. Assemble the mount as shown with the

antenna mount plate outside the bent base plate

but the antenna towards the inside.

4. Snug up the pivot bolt then lock the jam nuts

tight so it doesn't loosen off. Test the break

away feature to ensure it is mounted solid yet

will break way if contacted or if positioned for

storage.

5. Attach the cable to the Wi-Fi antenna ensuring

there is enough slack for it to pivot down for

storage.

WiFi port

CL55

(mounted in

the cab)

To ethernet

port on back of

console

6. Stick on the flat network antenna to the base

7. Route all antenna cables inside the cab and

1.1.2

1. Tee in the power leads of the CL55 harness to

2. Connect the Cl55 harness to the CL55 module.

3. Connect the ethernet cable to the port on the

4. Connect the Wi-Fi antenna cable to the Wi-Fi

5. Connect the blue and purple leads from the

6. Position the Cl55 module in a location inside

7. Secure all cables.

GPS & Cell

networl leads

Tractor

Diagnostics

- not used

Tee in Power

leads to console

CAN leads

harness

- not used

Figure 1 - CL55 Kit

plate as shown.

secure.

CL55 and Harnesses

the switched power connector on the console

harness. This will make the CL55 module

power up or shut down when the console is

turned on or off.

CL55 module and the other end to ethernet

port on the back of the console.

port on the CL55 module.

network antenna to the respective ports on the

CL55 module. Tie up the other unused leads

from the network antenna.

the cab where the LED's will be visible.

Wi-Fi antenna

(mounted on the

tractor roof)

Network antenna