3onedata IES5028-4GS-24F Handbuch zur Schnellinstallation - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Schalter 3onedata IES5028-4GS-24F herunter. 3onedata IES5028-4GS-24F 4 Seiten. Managed industrial ethernet switch

Seite drucken

Relay output terminal block

10.

Gigabit SFP slot

11.

Ethernet port connection indicator

12.

100M copper port

13.

100M fiber port

【Mounting Dimension】

Unit: mm

Attention before mounting:



Don't place or install the device in moist area or near

water, keep the relative humidity of the device

surrounding between 5%~95% without condensation.



Before power on, first confirm the supported power

supply specification to avoid over-voltage damaging the

device.



The device surface temperature is high after running,

please don't directly contact to avoid scalding.

【Installation of Rack-mounted Device】

Step 1

Select the device installation location to reserve

sufficient size.

Step 2

Adopt screws to install the mounting lugs in the

device position as figure below.

Step 3

Place the device in the rack, adopt 4 screws to

install the mounting lugs on the left and right side in

the rack.

Step 4

Check and confirm the product is firmly installed on

the rack, then mounting ends.

【Rack-mounting Device Disassembling】

Step 1

Power off the device.

Step 2

Unscrew the fixing screw of mounting lug on the

rack.

Step 3

Remove the device from the rack, disassembling

ends.

【Power Supply Connection】

This series of devices provide 5 pins 5.08mm pitch terminal

blocks, power supply occupies 3 pins on the left.The power

supply has nonpolarity and anti-reverse function, the device

can be normally working after reverse connection. The pin

definition of power supply as follows:

Pin NO.

Definition

L/+

GND



Single power supply

This series of products supports single

power supply scheme, power supply

value range is: 100~240VAC/DC.



Dual power supply

This series of products support dual

power supply scheme and provide P1

and P2 independent power supply

systems. When one of the power supply

system fails, the device can operate

uninterruptedly and normally, which has

improved the reliability of network operation. Power supply

value range is: 100~240VAC/DC.

Notes:



Power ON operation: First insert the power supply

terminal block into the device power supply interface,

and then plug the power supply plug contact and power

on.

Power OFF operation: First unpin the power plug, and



then remove the wiring part of terminal block, please

pay attention to the operation order above.

【Relay Connection】

This series of devices provide 5 pins 5.08mm pitch terminal

blocks; power supply occupies 3 pins on the left. Relay

terminals are a pair of normally closed contacts in device

alarm relay. They are open circuit in normal non alarm state,

closed when power off. This series of single and dual power

supply products respectively support 1 or 2 channels relay

alarm output and disconnection alarm of power supply or port.

The device can be connected to alarm indicator, alarm buzzer,

N/-