DTM System UVR-2 Betriebshandbuch

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Empfänger DTM System UVR-2 herunter. DTM System UVR-2 2 Seiten.

Seite drucken

V. Examplary electric scheme

230V AC

Channel 2 manual

Control button

Channel 1 manual

Control button

IN1

IN2 IN2

Fig.3 UVR-2 receiver and electrical devices conection exemplary scheme

VII. Warranty

DTM System checks all the devices before shipping. The

warranty time is 24 months from the selling date. This time

is counted according to the warranty label. The

manufacturer will fix all the problems which come because

of his fault. Non functioning device should be delivered

back to the distributor with short problem description. The

cost of mount/dismount is covered by user. The warranty

do not cover: batteries in the remotes, faults caused by

improper usage, user self repairs and adaptations,

lightning strikes, over voltages or short circuits in the

mains supply. Appropriate legal acts regulates details of

the warranty.

The intention of the WEEE Directive

(Directive 2002/96/EC on waste electrical

and electronic equipment) is to reduce the

amount of hazardous substances in waste.

The underlying purpose is to promote the

avoidance, recovery and risk-free disposal

of waste.

ELECTROLOCK

OR OTHER LOW VOLTAGE

DEVICE

230v SUPPLIED

DEVICE

~230V

NO1

NC1 NO2

NC2

UVR-2 RECEIVER

VII. Declaration

UVR-2 Receiver Operating manual

I. Used terms

Monostable output mode – turn on for programmed time after pushing the button

Bistable output mode – switch to opposite (turn on or turn off) after pushing button

Momentary output mode – turn on as long as the button is being pushed

Manual control – operating controled by momentary buttons connected to UVR-2 board.

12V AC

II. General information

Remote control receiver

UVR-2

230V loads, up to 600W. UVR-2 is compatible with DTM remotes. Exemplary application: control of gate automatic,

pomps, lightning, alarm system and more.

III. Technical data

receiver supply 230 V AC

superherterodyne receiver, work frequency: 433.92 MHz,

dynamically variable code Keeloq gives high class safety

two separated relay outputs, NO or NC, max load for each output 600W

max peak current 16A/230V AC

two manual control inputs

three working mode: bistable, momentary, monostable (1s resolution for times up to 1 minute and 1min resolution for

times from 1min to 127min)

discretion with ascribing remote buttons to receivers outputs

hardware interface with 6 diodes

receiver's memory containing 35 remote controls of ZSP series

remote radio range up to 150m

single remote removing possibility

working temperatures from -20 C to +55 C

two enclosure versions: surface mounted, inside mounted, IP55

dimensions: surface mounted enclosure: 89 x 89 x 52 mm or install box of 80 mm diameter, 40 mm depth

IV. Receiver installation

This installation should be made by a qualified service person and should conform to all local codes.

Turn all power off while installing. System should be installed with safety, to minimalize potential risk of using.

1. Device description and installation

Receiver consists of main board and case. Main board contains: power supply, microprocessor user interface

with LED diodes, buttons and jumper, executive circuit on two relays, terminal blocks for: power supply, controlled

was made for universal use – remote or manual control of electrical devices of heavy

CAUTION!!

Device is designed to operate with high voltages.

Fitter is responsible for any presumptive damages.

Made in

Poland