DTM System ZSP Rival 432 Betriebshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Empfänger DTM System ZSP Rival 432 herunter. DTM System ZSP Rival 432 4 Seiten.

Seite drucken

1) Registering remote control to receivers memory

Registering remote control do receivers memory is adding particular button with simulataneously assing recivers

output.

It is possible to assing few of buttons to the same channel or to assing remote control button to both of channels.

To remove programmed button, it is necessary to delete remote control from receiver's memory, and assing buttons in right

confriguration (point 3).

Button registering

While pushing output button

Remarks!

If pushing output button

programming mode. To exit push shortly other channel button.

2) Easy remote control registering

It is possible to register new remote control without using receiver's buttons. New remote control must be in radio

range of receiver and previously registered remote control presence is necessary. Easy remote control registering is

unavailable if output is on momentary mode.

a) push and hold for 15 sec. any button of previously registered remote

b) within 3 sec. after releasing the previous button push and hold for 15 sec. any button of new remote control

c) new remote control is registered with same as previous remote configuration.

Remarks!

Failure in registering may be caused by radio interferences, low batteries or lock of easy remote registering

function.

3) Simple remote control removing

To remove single remote control from receiver's memory push and hold simulataneously output buttons (C1 and

C2). All of LED diodes (except for green LED diode) will light. During lighting push any remote control's button that you want

to remove. Diodes will wane, remote will be removed from receiver's memory.

Remarks!

If you hold the receiver's C1 and C2 buttons for too long, receiver's memory will format.

4) Output (C1/C2) mode change to

For monostable mode check point 5.

Output's factory settings:

C1 output working mode – monostable (0,5s)

C2 output working mode – monostable (0,5s)

To change mode of C1 or C2 output push and release chosen output button. Red LED diode will light

Yellow LED diode shows actual output mode. Push output button several times to set working mode. Yellow LED diode with

MOM

sing for momentary mode,

chosen mode push and hold output button (C1/C2). Red LED diode will light and wane. Working mode is registered.

5) Output (C1/C2) mode change to

To change output mode to monostable push and release button

diode which shows actual output mode will light. Push output button to set working mode on monostable, signalized by

yellow LED diode with

MONO

fade, than start to blink. Hold output button for wanted turn on time in seconds. Number of blinking set turn on time in seconds

(or minutes if after releasing in short time button is being pushed for second again.)

Remarks!

To set turn on time 0,5s release

(C1/C2)

push choosen remote control's button. LED diode will light.

C1/C2

stops before pushing transmitter's button receiver will turn on output

bistable

momentary

BIST

sing – bistable mode,

monostable

sing. To approve push and hold edited output button (C1/C2). LED diode with MONO sing will

C1/C2

button before yellow diode with

MONO

sing – monostable mode (check point 5.) To approve

(C1/C2)

, red LED diode will light and yellow LED

MONO

sing light.

(C1/C2)