Comtech EF Data CDM-625 -5V Montageanleitung Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Netzwerk-Hardware Comtech EF Data CDM-625 -5V herunter. Comtech EF Data CDM-625 -5V 6 Seiten.
Seite drucken5. Power down the unit, remove the power harness and apply RTV to U94 between the output pin and PCB
pad to ensure electrical isolation.
6. Remove the (2) screws holding the CnC module. Solder 2pin right angle header connector
(CN/HED02MSR01) on CnC board (PL/12875-1) J1 pins 35-36 & 37-38 as shown below. Re-install
CnC board and two mounting screws.
WARNING - This document contains U.S.-origin data, the re-transfer of which is restricted by the Export
Administration Act and Export Administration Regulations (15 C.F.R. 770, et seq.)
RTV
OLD CnC
No connector
NEW CnC
with connector
D-0020532 REV-D