Comtrol ROCKETLINX ES7110 Handbuch zur Schnellinstallation - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Schalter Comtrol ROCKETLINX ES7110 herunter. Comtrol ROCKETLINX ES7110 6 Seiten. Industrial poe switch
Seite drucken
DIN Rail Mount
The DIN rail clip is already attached on the rear side of the ES7110.
1. Insert the upper end of the DIN rail clip into the back of the DIN rail track from its
upper side.
2. Lightly push the bottom of the DIN rail clip into the track.
3. Verify that the DIN rail clip is tightly attached to the track.
Connect the Ethernet or PoE Ports
You can use the following information to connect Ethernet cables between the ES7110
ports and the network nodes.
Ports G1 and G2 are Gigabit Ethernet ports that support 10BASE-T,
100BASE-TX, and 1000BASE-TX.
Ports 3-10 are Fast Ethernet 10/100BASE-TX PoE ports that are IEEE 802.3af
(PoE) compliant. The Fast Ethernet ports support 10BASE-T and 100BASE-TX,
full- or half-duplex modes.
The following table shows the RJ45 pin-out assignments for the PoE and Gigabit ports:
RJ45 Pin
10/100BASE-TX PoE
Number
Signal
1
RX +-
2
RX -
3
TX +
4
Vport+
5
Vport+
6
TX -
7
Vport-
8
Vport-
1000BASE-TX
Signal
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
3