ABSTRACT Universal Gebrauchsanweisung - Seite 11

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für DJ-Ausrüstung ABSTRACT Universal herunter. ABSTRACT Universal 19 Seiten.

Abstract Universal Instruction Manual

Maintenance of the unit

In typical use, the unit will get dirty due to smoke fluid, dust and cigarette
smoke.
Every few weeks you should clean the mirror and lens of the unit using a soft
damp cloth to ensure maximum light output. Do not use abrasive cleaners or
solvents to clean the optics of the unit. Using a vacuum cleaner, remove fluff
from the fan outlet and the air intakes on the unit. If the airflow becomes
restricted or blocked, the unit will overheat. This will shorten the working life of
the unit and may result in the thermal trip activating on Club series units.
If you are operating the unit regularly for prolonged periods (e.g. nightclub
installations) you should take the unit to an Abstract dealer for full servicing and
internal cleaning a few times a year. Do not attempt to open the case yourself as
electrical hazards are present inside, and you risk damaging delicate internal
parts.

Lamp replacement

To replace the lamp, first turn off the unit, remove the power, and if the unit
has been operating, wait 15 minutes for it to cool down.
Club range units: Remove the lamp by taking out the thumbscrews in the end
plate and withdrawing the lampholder through the rear end of the case.
Remove the old lamp from the lampholder and fit the new lamp.
You must not touch the quartz glass of the lamp! Handle by the
ceramic base only.
Replace the lamp into the unit and refit the thumbscrews. Power up the
unit. Adjust the lamp for best brightness and evenness of light using the 3
screws on the lamp plate.
Futurescan 1, Gladiator Revolution and Duo Colour: Open the hatch on the top
of the unit by removing the thumbscrew. Slide out the old lamp. Pull the
connector off the lamp and plug it onto the new lamp. Refit the lamp.
Close the hatch.
Twister 4 and Galactic Star: Open the hatch on the front of the unit by removing
the two thumbscrews. Slide out the old lamp. Pull the connector off the lamp
and plug it onto the new lamp. Refit the lamp. Close the hatch.
Page 11