ADDER AdderView Omega Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter ADDER AdderView Omega herunter. ADDER AdderView Omega 20 Seiten.
Auch für ADDER AdderView Omega: Schnellstart (2 seiten)

Seite drucken

Making connections

Connecting your AdderView Omega

Within these

connection

instructions,

the following

terms are used

to refer to the

four sides of

your AdderView

Omega.

Location tips

Before connecting your AdderView Omega, first decide where you will

position it:

• AdderView Omega can be located on your desk, on the floor or

can even be attached to a wall or desk side using Velcro strips (not

supplied).

• There is no need for a power socket as a small amount of power is

taken from the keyboard ports of your computers.

• You do not necessarily need to have constant access to the Omega

button (located on the top panel) because, if you wish, you can

change channels using your keyboard or mouse.

Non-standard connections (RS232, AT and USB)

• RS232 mouse connections (9-pin D-Type plug) are NOT supported

by your AdderView Omega.

• AT keyboards (5-pin DIN style plug) are supported by your

AdderView Omega, however, a standard 'AT style to PS/2

converter' will need to be used – These converters may be

purchased from Adder Technology Ltd.

• USB keyboards and mice may NOT be connected to your

AdderView Omega. However, your AdderView Omega can itself be

attached to the USB port of a computer and then a standard

keyboard and mouse can be used to control that system – please

refer to the section 'USB keyboard and mouse connections'.

Standard connection procedure

You can choose to connect your AdderView Omega in any order,

however, we suggest the following:

1 Switch off both of your computers. If it is not possible to switch

off a computer (due to it running software that cannot be

interrupted) your AdderView Omega may be connected while the

system is running. This is called 'hot plugging' and before starting

you should read the section 'Hot plugging and mouse restoration'.

2 Connect the cables from your keyboard, mouse and monitor to

the three sockets at the bottom end of the AdderView Omega.

Note: For ease of recognition the cable set plugs and AdderView

Omega sockets are color matched. Alternatively, on the underside

of the AdderView Omega, each socket is labeled with an

appropriate icon. Your computer(s) may or may-not use equivalent

markings:

Monitor (video)

Keyboard

Mouse

Speaker

Microphone

Blue

Purple

Mid green

SPK

Light green

MIC

Pink