Auber WS-1500EBPM Betriebsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Temperaturregler Auber WS-1500EBPM herunter. Auber WS-1500EBPM 19 Seiten. Ws series precision pid temperature controller

Seite drucken

Figure 5. How to remove the sensor.

3) Programming the temperature profile.

A total of 6 steps can be programmed with this controller. Each step contains the

temperature (C0X) and time duration (T0X) setting. They are represented by the symbol

C0X and T0X, where "X" is the step number (e.g. Step 4 temperature is represented by

C04 and step 4 time is represented by T04). The character, "T", is displayed as the

symbol, " ". Time is defined as the duration between the last step and the next step.

Please make sure the time is long enough for the heater to heat up the oven. If the time

is set too short, the temperature may not be able to reach the current step temperature

setting, before it jumps to the next step. The time unit is in minutes with 1 minute

resolution. If the recipe only needs one step, you can program the time of the rest of the

steps to zero.

To program the temperature profile, press SET key once. The display will show C01 for

one second and then display the temperature setting for step 1. Use "+" and "-" keys to

change the temperature setting. When finished, press the SET again to confirm the

change. The display will show T01 for a second and then change to the cook time setting

for step 1. Use "+" and "-" keys to change the cook time setting. When finished, press the

SET again to confirm the change. The display will go the step 2 setting. The following is

the flow chart for the setting procedure.