Comway WG8010 Handbuch zur Schnellinstallation - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch zur Schnellinstallation für Modem Comway WG8010 herunter. Comway WG8010 7 Seiten. Cellular ip modem
Auch für Comway WG8010: Benutzerhandbuch (18 seiten)

Seite drucken

WG8010 cellular IP modem Quick Installation Guide

1.4 Connecting the Power

Connect the 5 to 16 VDC power cord with the WG8010 IP Modem's power input. If the

power is properly supplied, the "PWR" LED will glow a solid green color to indicate that

the system is ready.

1.5 LED Indicators

The LED indicators on the front panel of the WG8010 IP Modem are described in the

following table.

DATA LED blinking

PWR, LINK LED blinking

PWR blinking

LINK LED Permanently on

2. Configure WG8010 with AT command

2.1 Determine which Com Port to Use

Step 1． On older computers, there is usually a built in Com port. This is normally Com1.

Step 2． If you are using a USB-to-serial converter, you will need to determine which Com port

it is installed on.

Note: If the USB-to-serial converter has not been installed, install the necessary

drivers per the instruction supplied by your USB-to-Serial device. Then

leave the device unplugged.

Step 3． Open up the System Properties window. This is done through the Control Panel

→ System or right-click on My Computer and select Properties. Select the

Hardware Tab.

Step 4． Select the Device Manager button. Expand the Ports section by selecting the + sign

Signal

RXD

TXD

GND

LED status

Page 2 of 7

Signal

Device Status

Data

transmission

Not registered

Net search

Online