Dan D'Agostino Momentum Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Dan D'Agostino Momentum herunter. Dan D'Agostino Momentum 13 Seiten. Hd preamplifier
Auch für Dan D'Agostino Momentum: Benutzerhandbuch (13 seiten), Benutzerhandbuch (10 seiten), Benutzerhandbuch (15 seiten), Benutzerhandbuch (11 seiten), Benutzerhandbuch (11 seiten)

Seite drucken

1. During Operation

Making connections to the

MoMentuM MonobLock aMPLiFieR

Speaker cables

Install the speaker cables first. We recommend the use of high-quality cables terminated

with spade or ring lugs that will fit the Momentum's binding posts. We advise against the use

of bare-wire connections.

Note that the positive (+) binding post has a red ring and the negative (-) binding post has a

black ring. Double check to confirm that you are connecting your speaker cable's conductors

to the appropriate binding posts—red to positive, black to negative. If your cables are marked

to show desired signal flow, orient the cable so that the installation conforms to the cable

manufacturer's instructions.

Carefully loosen each speaker binding post to install speaker cables tipped with spade lugs

or rings. Turn counter-clockwise to loosen. If using spade lugs, insert each spade lug so that

its two tines straddle the binding post, then tighten the binding post nut with a binding post

wrench. If using rings, remove the binding post nut entirely, place the ring on the binding post,

then replace the nut and tighten it securely.

A firm connection, tight enough that the spade lug or ring cannot move, is all that's needed.

Do not use a conventional wrench to tighten the binding posts. Be sure the wires are not in

contact with one another.

Interconnect cables

We recommend the use of high-quality balanced XLR audio interconnect cables with the

Momentum amplifier. If your preamp does not offer XLR output, use the high-quality RCA-

to-XLR adapter provided with the Momentum amplifier.

Connect the XLR cable to the input by pushing the cable onto the jack. To release the XLR

cable, push on the small tab on the end of the jack then grasp the cable by the plug and gently

pull it out. Never grasp interconnect cables by the cable itself—you could damage the cable.

AC cord

The Momentum amplifier is supplied with a high-quality AC cord tipped with a 15-amp IEC

connector at the amplifier end and a three-conductor AC plug at the other end. You may use

a different power cord with the Momentum amplifier if you wish, as long as it is tipped with a

15-amp IEC connector and a three-conductor AC plug.

After the speaker and interconnect cables are connected, push the IEC connector on the

power cord into the IEC jack on the Momentum amplifier.