Dan D'Agostino Momentum Benutzerhandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Dan D'Agostino Momentum herunter. Dan D'Agostino Momentum 15 Seiten. Hd preamplifier
Auch für Dan D'Agostino Momentum: Benutzerhandbuch (13 seiten), Benutzerhandbuch (13 seiten), Benutzerhandbuch (10 seiten), Benutzerhandbuch (11 seiten), Benutzerhandbuch (11 seiten)
Seite druckenFront indicator is illuminated but you hear no sound
Follow these steps in order. if one step succeeds in restoring the sound, stop there and ignore
the other steps.
1.
Check your amplifier and source device to make sure they are both turned on.
2.
Check the source device to make sure it is playing, i.e., if it's a record player, make sure
it's spinning and the tonearm is lowered, or if it's a CD player, make sure it's in play
mode and not in pause.
3.
Make sure the preamp is not muted and that the desired source is selected.
4.
Check the line-level connections between the source device and the preamp, and
between the preamp and the amplifiers. Reconnect any cables that may have
become disconnected.
5.
Check the cables between the amplifiers and the speakers to make sure they are
properly connected and that the cables have not become damaged.
6.
if you have a spare pair of interconnect cables (even inexpensive ones will work
temporarily), try using them instead of the interconnect cables between the source
device and the preamp and between the preamp and the amplifier. if this restores
sound, replace the defective cables.
7.
if all of these steps fail to restore sound, consult your dealer for service.
Sound comes from only one channel
Follow these steps in order. if one step succeeds in restoring the sound, stop there and ignore
the other steps.
1.
Push the Balance button on the remote to see what the setting is. if the needle on the
front dial is moved to one side, hold the Balance button on the remote down for 2
seconds. The remote's backlight will flash and the needle will return to the center.
2.
Check the interconnect connections between the source device and the preamp, and
between the amp and preamp to make sure all cables (and XLR-to-RCA adapters, if
you're using them) are securely connected.
3.
Check speaker cable connections for the malfunctioning channel. Reconnect any
cables that may have become disconnected. inspect the cable to make sure it has not
been damaged. if it has been damaged, replace it.
4.
if you are using monoblock amplifiers, such as the Momentum amplifier, make sure both
amplifiers are turned on.
5.
Swap the left-channel interconnect cable from the preamp to the amplifier with the
right-channel interconnect cable. if the malfunctioning channel now works but the other
channel does not, replace the defective interconnect cable with one of the exact same
type. You may have to replace both right and left cables to make sure they match.