Elite Cedar 2436BS Montageanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Montageanleitung für Rasen- und Gartengeräte Elite Cedar 2436BS herunter. Elite Cedar 2436BS 2 Seiten. Planters

Seite drucken

ASSEMBLY:

Step 1: Position two legs to your left and right, one set of slots facing each other,

the other slots facing toward you.

NOTE: Place the best side of the panel toward the side of the leg with no slot.

Insert Panel into facing slots of left and right Legs. Should be a tight fit.

Step 4: Place eight (8) slats inside the planter, resting on the Bottom Supports. NOTE: Place the Slat

with pre-drilled holes in center of the panel (see arrow in picture). Evenly space the slats. The slats on

the ends should be against the legs.

Step 5. Secure the middle slat with SMALL screws into the pre-

drilled holes. (DO NOT OVER TIGHTEN)

Step 6: Position Corner Caps on top of Legs. Caps hang over

outside of leg roughly 3/8 of an inch. Fasten with SMALL screws

using pre-drilled holes. DO NOT OVER TIGHTEN

PHARMTEC CORPORATION / PO BOX 919 / Bath, Ohio 44210-0919

Step 2: Insert Panels with BOTTOM SUPPORTS into those legs, Bottom

Supports toward you. Repeat for other Panel with Bottom Supports. USE

the SLOTS as per the picture above. Then, slide END panels into Legs of

completed panel. Should look like picture to left.

Step 3: Lock Panels into legs. Using the supplied Wood Block and a

hammer, drive the panel until flush with top of leg. (See pictures)

Step 7: Position Bottom shelf at desired height (suggest 14" down

from upper panel), and slightly in from the edge of the leg. Secure

with four (4) Large screws in the holes closest to the slats. Use

four (4) Medium screws in the lower pre-drilled holes.

Step 8: Place filter fabric inside of the planter, covering the bottom

and up the sides. Fold the fabric in the corners. You may need to

trim the fabric with scissors.

Questions?

Please call 877-833-2221

330.659.6575 / Fax 330.659.9049 / www.pharmtec.com