Ducati 1098R 2008 Einbauanleitung - Seite 4

Blättern Sie online oder laden Sie pdf Einbauanleitung für Controller Ducati 1098R 2008 herunter. Ducati 1098R 2008 5 Seiten. Dynojet power commander iii usb

Seite drucken
PCIII connector
PCIII harness
Ground wire
from PCIII
i736-411
www.powercommander.com
Stock connector
Grey wire
12
Repeat steps 9 &10 for the front
cylinder.
Plug the ORANGE colored wires
from the PCIII in-line of the stock
injector and GREY connector.
Plug the YELLOW colored wires
from the PCIII in-line of the stock
injector and BLACK connector
(Fig. H).
13
Remove the right hand fairing.
14
Route the PCIII harness along the
right hand side frame down tube. Use
the existing wraps to hold the PCIII
harness in place (Fig. J).
15
Locate the Throttle Position Sensor
on the right hand side of the throttle
bodies.
16
Crimp the supplied wire tap to the
TPS
ORANGE wire (C position).
17
Connect the GREY wire from the
PCIII to the wire tap.
It is recommended to use dielectric
grease on these connections.
18
Attach the ground wire from the PCIII
to the right hand engine cover bolt
shown in Figure K.
19
Reinstall the right hand fairing.
2008 Ducati 1098R - PCIII USB - 4