Abtech APC10 Anweisungen für Installation, Betrieb und Wartung - Seite 2

Blättern Sie online oder laden Sie pdf Anweisungen für Installation, Betrieb und Wartung für Sicherheitsausrüstung Abtech APC10 herunter. Abtech APC10 2 Seiten.

Seite drucken
Operation
1. The APC Photocell is fitted with current overload and thermal protective devices which cannot
be reset. The APC Photocell should not be used outside its rated voltage and current.
2. The lid must be secured using all of the lid screws provided in order to maintain the IP rating.
3. No attempt must be made to remove the enclosure lid whilst electrical power is connected to
the contents of the enclosure.
4. The mains power input going into the APC (via the L terminal) is the same as the output (Ls).
The photocell acts purely as a switch, it does not alter the supply.
Maintenance
Routine maintenance is likely to be a requirement of local Health and Safety legislation. The laws
of the applicable country must be considered and maintenance checks carried out accordingly.
Additional periodic checks that are advisable to ensure the efficiency of APC Photocell are:-
Activity
1
Check that the lid seal is in place and not damaged
2
Check that all lid fixing screws are in place and secured
3
Check that the mounting bolts are tight and free of corrosion
4
Check the security of all cable glands and entry devices
5
Check that all screw clamp terminals are secure
6
Check enclosure for damage
7
Ensure photocell window is clean
Chemical attack
The APC Photocell enclosure is manufactured using the following materials:- glass reinforced
polyester resin (with or without carbon loading), polycarbonate, neoprene or silicone rubber, 316
grade stainless steel, brass.
Consideration should be given to the environment in which these enclosures are to be used to
determine the suitability of these materials to withstand any corrosive agents that may be present.
Static hazard
Glass reinforced polyester resin and polycarbonate has a surface resistance greater than 10E9
Ohms. They can present a hazard from static electricity and may not be cleaned except with a
damp cloth.
Vibration
The APC Photocell is designed for use in areas subject to normal industrial levels of vibration. It is
not designed for use in areas subject to intentional or extreme conditions of vibration.
Wiring Diagram
Abtech Limited, Sheffield, S9 2QJ, United Kingdom
Frequency
Each time the enclosure is opened
Each time the enclosure is closed
Every 3 years
Every 3 years
As per manufacturer's recommendations
Every 3 years
Every 1 year
ABTQ-92 rev 02
Last review: 08-08-17
2/2