Duco 0000-5132 Installationshandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Installationshandbuch für Fan Duco 0000-5132 herunter. Duco 0000-5132 16 Seiten.

Seite drucken

ENGLISH

Press 'HIGH' or 'LOW' to activate the configuration mode for 30 minutes�

Then close the cover firmly.

Which configuration mode should I choose?

Button

The percentages in the table indicate what percentage of the flow rate configured will be extracted�

The configuration mode chosen does not affect the operation of the AUTO mode�

* In the 'LOW' configuration, the percentage in low mode and boost mode is dependent on the type of

home (see section "06�D Setting type of home" on page 11) and limited to the maximum achievable

ventilation system flow rate�

Close the DucoBox cover�

Ensure it forms an airtight seal with the DucoBox�

Select the duct with the highest flow rate and restriction�

Measure at the vent and adjust the DucoBox rpm until the desired flow rate is

obtained� This can be done in two ways:

• Using the

Humidity Sensor*�

• Using the 'DOWN' and 'UP' buttons on the DucoBox� This requires the cover to

be removed temporarily� Always close the cover after every measurement.

Pressing the buttons once is equal to 1% (= approximately 2 to 3 m3/h per press of the button depending

on the restriction in the ducts)�

Now measure the other vents� The flow rate from these other vents must only be

adjusted at the vents themselves.

Repeat steps

Exit configuration mode� This can be done in two ways:

• Long-press 'AUTO' on a paired User controller or CO

the 4 LEDs light up white briefly and then turn yellow again�

• Press 'ENTER' in the DucoBox and then immediately close the cover on the

DucoBox� If the cover was not closed, you can pull the plug out of the power

socket for a few seconds after closing the cover in order to reboot the DucoBox�

The DucoBox will now perform a calibration by speeding up high� This may take up

to 1�5 min� Calibration will be complete once the DucoBox slows down the 'AUTO'

button LEDs on the User controllers / CO

will the LED on the DucoBox�

* Depending on the software version of the User controller / CO

L2000641 Installation guide for DucoBox Silent (Revision H | 13.07.2020)

Air calibration using 'HIGH'

This method is standard and has the

lowest consumption� Recommended

in the majority of homes�

Low mode (10%)

Medium mode (50%)

High mode (100%)

(lower) and

(higher) buttons on a paired User controller or CO

and

until the desired flow rate has been obtained at each vent�

/Humidity sensor�

Air calibration using 'LOW'

This method offers a boost mode

but may give rise to more noise

and higher consumption�

Low mode (14-33%)*

High mode (100%)

Boost mode (143-333%)*

/Humidity sensor* until

/Humidity sensors* will turn white, as

HIGH

LOW

ENTER