anytronics Anyscene 1 Installations- und Betriebshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Controller anytronics Anyscene 1 herunter. anytronics Anyscene 1 6 Seiten. Memory unit
Seite drucken
6. Unit Configuration
6.1. Fade Rate
The full-scale fade period from one scene to another can be adjusted using the second
DIL switch marked CYCLE (Preset & Auto). The adjustment is as follows,
7. Programming
As supplied, the Anyscene 1 scene memories have a range of saved presets allowing
electrical contractors to confirm correct operation before final commissioning of the
system. They can be easily programmed from any source of DMX data including another
Anytronics scene memory, DMX lighting desk or a computerised lighting system.
Anyscene should be programmed whilst connected into the final installation and the
programming source should be connected into the system.
a) Turn on the CD01 DIL switch
b) Connect the DMX programming source (DMX Desk etc.) into the system
c) Power the DMX programming source
d) Power the Anyscene 1, the power and yellow data LED should be lit
e) Use the DMX programming source to adjust the required channels
f) Press and hold the button on the Anyscene 1 where the current scene should be
saved
g) The Anyscene 1 data LED will flash twice to show the data has been saved.
h) Repeat e) to g) for all required scenes
i)
Once all scenes have been saved turn the CD01 DIL off to protect the unit
Note: that unless this data LED is illuminated, and unless the internal CD01 DIL switch is
in the ON position, no programming of the scenes will be possible.
Units 5 & 6 Hillside Industrial Estate
London Road, Horndean,
Hampshire, PO8 0BL
Tel +44 (0)23 9259 9410
Fax +44(0)23 9259 8723
CYCLE DIL
Fade Time (Seconds)
OFF
ON
Page 5 of 6
5
10
Anyscene 1 Operating
The
AT1042 Issue 1
Instructions