Anywhere Fireplace Hudson Einbauanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Einbauanleitung für Innenkamin Anywhere Fireplace Hudson herunter. Anywhere Fireplace Hudson 4 Seiten.

ASSEMBLY INSTRUCTIONS

We recommend you assemble your fireplace on a carpeted surface or towel to prevent damage to your floor or the fireplace.

Step 1

You will notice 2 pieces of glass are a little

wider than the 3rd piece (Parts B). The 2

wider pieces are to be used on the sides of

the fireplace body (Part A) and the narrower

to be used for the back panel. Also please

notice that the body of the fireplace has

holes on 3 of the 4 sides.

Step 2

Note: The fireplace is designed to be suspended between three glass

pieces. The holes in the glass are 5.25 inches from the bottom of the

glass. Select the narrow glass panel (back panel), holding it upright

with the holes in the glass closer to the floor, and insert the rubber

washers (Part E) into the holes. Insert the black screws (Part D)

into the rubber washers.

Step 3

Align the holes on the back of the fireplace body (opposite the side

with no holes) with the screws. Take a nut and washer (parts G and

F) and hold it up to the screws from the underside of the fireplace.

Hand tighten the screws while holding the nut in place.

Hand tightening of the nut and screw should be sufficient however

if you intend to move your fireplace often to different locations, we

suggest you always check that the screws are tight or tighten with a

wrench or pliers. Be sure not to over tighten.

Step 4

Lay the fireplace body and glass on the floor so that the side of the

fireplace body without pre drilled holes is facing up. Insert the

rubber washer and black screw into the holes in the glass and line up

one of the side pieces of glass with the holes on the side of the body.

Secure this glass with the nut and washer by tightening the black

screw while holding nut in place. NOTE: When properly assembled,

glass should be flush with the front of the body and extend approxi-

mately ¼ inch off the back of the fireplace body to make a perfect 90

degree corner where the side and back glass pieces meet. Repeat

same step for the 2nd side of glass.

Step 5

Slide clear rubber floor protectors strips (Part H)

to bottom of the fireplace glass and turn it upright.

If rubber is longer than the glass, you can cut this

to proper length with scissors.

FRONT - no holes