Anzzi ENVO WH-AZ035-M1 Handbuch für Installation und Betrieb - Seite 6
Blättern Sie online oder laden Sie pdf Handbuch für Installation und Betrieb für Warmwasserbereiter Anzzi ENVO WH-AZ035-M1 herunter. Anzzi ENVO WH-AZ035-M1 16 Seiten. Electric instant water heater
Seite drucken
SAFETY PRECAUTIONS
ATTENTION
It is extremely important to FLUSH the
●
pipes to wash away sundries and residue in
the pipes before connecting the water heater
to it.
Risk of Fire - Hydrogen gas can be produced
●
in a hot water system served by this water
heater that has not been used for a long period
of time(generally two weeks or more).
HYDROGEN GAS IS EXTREMELY FLAMMABLE!!
To dissipate such gas and to reduce risk of
injury, it is recommended that the hot water
faucet be opened for several minutes at the
kitchen sink before using any electrical
appliance connected to the hot water system.
If hydrogen is present, there will be an unusual
sound such as air escaping through the pipe
as the water begins to flow. Do not smoke or
use an open flame near the faucet at the time
it is open.
Safety regulations require a factory setting no
●
greater than 125°F (52°C) for all new water
heaters. Therefore, if your old water heater was
set to a hotter temperature than your new water
heater with a factory setting of 120°F (49°C), the
new water heater may seem to provide lower
capacity than your old water heater. This can be
corrected by increasing the temperature setting.
CAUTION
FOR HOUSEHOLD AND INDOOR USE ONLY.
SAVE THIS INSTRUCTION
PG.2
Increasing the water temperature setting
●
may improve the cleaning performance of
dishwashers.
The user can adjust the temperature setting
●
to meet their needs. Always read and
understand the safety instructions contained in
the manual before adjusting the temperature
setting.
If the water heater is to remain idle for an
●
extended period of time, the power and water
to the appliance should be turned off and the
water heater drained to conserve energy and
prevent a buildup of dangerous hydrogen gas.
This unit has no power button, power can only
be shut off at the circuit breaker or disconnect
switch. The water heater and piping should be
drained if they might be subjected to freezing
temperatures. After a long shutdown period, the
water heater's operation and controls should be
checked by qualified service personnel. Make
certain that water is flowing to water heater
again before placing it in operation.
Statement: ENVO does not assume any
responsibility for the losses caused by the
improper installation and behavior listed
above or other improper operations.