Dancover ST03840 Handbuch - Seite 16

Blättern Sie online oder laden Sie pdf Handbuch für Zelt Dancover ST03840 herunter. Dancover ST03840 17 Seiten. Boat tent

Installation of mechanical door

The door dropping tube

assembly

(Seeing from inside)

Figure 13 Installation of the Mechanical Door

Step #9 --MECHANICAL DOOR INSTALLATION STEPS

1. Install Main Door Pulleys (left and right) over the Top of the Door on each side of the Door

Beam (Part #9).

2. Next mount the Winch Mechanism to the Front Panel Lower Beam (Part #12).

3. Slide Bottom Door Dropping Tube (Part15) into the bottom horizontal fabric pocket on the

Door Cover (Part #28). Then slide the six remaining Door Dropping Tubes (Part #14) into the

remaining horizontal fabric pockets in the Door Cover。

4. Raise the Bottom Dropping Tube (#15) to the top of the Upper Door Tracks. Put the Bottom

Dropping Tube (#15) into the tracks side to side so the ends start down the tracks. Gently allow

the Door Cover to go down, and feed the six remaining Door Dropping Tubes (#14) into the Door

Tracks.

5. Next install the steel wire that leads from the bottom of the door dropping tubes

to the door winching assembly. Take one of the Steel Wires in the Door kit, and feed

down from the top of the Door track to the Bottom Door Tube Dropping Tube (#15)

on the right hand side of the door (facing from the inside). When the steel wire goes

down though the hole in the Bottom Dropping Tube, tie a knot in the steel wire so that

it cannot pass back up through the hole.

6. From the Winch Assembly route leading end of the Longer Steel Cable through the

Upper Roller of the double the pulley near door track and then through the Single

Roller on the door track farthest from the Winch Assembly.

Then down through the Bottom Door Dropping Tube (15).When the steel cable goes

down though the hole in the Bottom Door Dropping Tube, tie a knot in the steel cable.

Door can now be operating the Winch Assembly. Raise and lower the door several

times to be certain door tube ends are not binding on track.. Lubricate if necessary.