3P Technik DTC200 Installations- und Betriebshandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Controller 3P Technik DTC200 herunter. 3P Technik DTC200 16 Seiten.

Timers

Allows setting the dosing and reaction timers.

Press the – or + button to increase or decrease the time for which the dosing pump will run. Pressing and

holding this button will produce a larger increase or decrease. Exit when done.

Press the – or + button to increase or decrease the time after dosing during which the reaction will be

allowed to take place. Pressing and holding this button will produce a larger increase or decrease. Exit when

done.

Press Change to enable or disable the High Level Alarm (Overflow Alarm), if the overflow sensor is not fitted

this alarm should be disabled. Press Exit when done.

NOTE - If an overflow is sensed during use the system will stop all filling or dosing activity and

immediately empty the tank. If this cannot be allowed (i.e. preferred option during high level sensor fault

is to overflow the tank) then you must disable this alarm.

Press Change to enable or disable the Low Level Alarm, if the overflow sensor is not fitted this alarm should

be disabled. Press Exit when done.

Activation of the Low Level Alarm during use does not prevent the tank from filling.

Enables and configures the optional output for a mixer/agitator or aeration pump.

Use the – and + buttons to choose between the following settings

Not Active – The output will remain off at all times.

•

While Reacting – On during the reaction delay time

•

While Dosing+Reacting – On during dosing and during the reactiion delay

All Except Draining – On during tank filling, dosing and reacting

•

Full Time – Output will be permanently live

Once the desired option has been chosen push button 4 to exit

Allows you to view the state of the level sensors or activate the outputs manually.

Displays the state of all 5 inputs, note than input 5 is unused in this product.

0 = closed circuit (no fluid)

1 = open circuit (sensor immersed)

DTC200 V1.20

Page 11

22/01/20