DANFI AUDIO TE-2017 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Drehscheibe DANFI AUDIO TE-2017 herunter. DANFI AUDIO TE-2017 11 Seiten. Bluetooth turntable with speakers
Seite druckenTROUBLE SHOOTING GUIDE
PROBLEM
GENERAL
No sound in general.
The unit does reset to operation of
any button
PHONO
No sound when playing vinyl
records
The sound is breaking up or
buzzing.
BLUETOOTH
No sound when playing audio via
Bluetooth
USB/TF
No sound in USB/TF mode
AUX
No sound in AUX mode
FM radio
No sound in FM radio mode
FM channel is not clear
POSSIBLE CAUSE
Volume not adjusted.
Source mode in wrong position.
Power cable disconnected or
loose.
Under the influence of electrostatic
phenomenon, the product may
malfunction and require user to
disconnect
Volume not adjusted.
There are many dust on vinyl
records
45RPM vinyl without use 45RPM
adaptor
There has obstacles when rotating
Your Bluetooth device has not been
paired properly.
The volume control of your
Bluetooth device is set at too low.
The volume control of the main unit
is set at too low.
Volume at minimum.
Your U-disk is in NTFS format
Volume at minimum.
External device not connected
properly.
Volume at minimum
The FM antenna not untie.
REMEDY
Adjust the Volume knob.
Using the Mode button, select the
proper function as required.
Check the connection or the
Power cable.
Turn off the unit, disconnect the
mains plug, and reconnect after a
few seconds.
Adjust the Volume knob.
Clean your records with an anti-
static cloth.
Use 45RPM adapter when play
45 RPM vinyl records
Remove the obstacles and put
the devise on a horizontal spot
Pairing your Bluetooth device
according to the Pairing name
"KXRM19" to a Device Section.
and playing Audio.
Increase the volume of your
Bluetooth device.
Increase the volume of the main
unit to turn to your wish.
Adjust the volume knob.
Change your USB drive
to FAT32/ FAT format
Adjust the volume knob.
Clear contacts pins and connect
again.
Adjust the volume.
Loosen the FM antenna back of
side, and adjust the external cable
position to get clear channel