Abu Garcia Orra Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Fischerei-Ausrüstung Abu Garcia Orra herunter. Abu Garcia Orra 6 Seiten. Low profile

C. THE ORRA FAMILY OF LOW PROFILE REELS:

Born from the Revo® series, the Orra™ family combines performance, reliability and precision

engineering.

D. HOW TO FILL THE SPOOL WITH LINE

All Orra™ low profile reels are designed for monofilament, braid and fluorocarbon lines.

Personal preference and fishing conditions will determine line selection. Begin by passing the

line through the guide located on the front of the reel. Secure the line to the reel using the arbor

knot. Control the filler spool by inserting a pencil into the spool hub. While maintaining tension

on the line with your fingers, wind the reel handle and continue to fill with line to approximately

1/16" (1.5 mm) below the top of the reel spool for best results (show picture). Do not overfill.

(CLICK HERE

to learn how to tie the arbor knot in this video)

Braided Line

Some anglers prefer to add a monofilament backing to the reel spool before attaching braided

line. This helps reduce line slip. Using the above instructions, fill the spool with enough

monofilament line to cover the spool. Tie the tag end of the monofilament backing to the

braided line using a uni-to-uni knot, Albright knot or equivalent. Continue to fill the spool with

braid to approximately 1/16" (1.5 mm) inside the upper lip of the spool. Do not overfill.

(CLICK HERE

to learn how to tie the uni-to-uni knot in this video)

E. DRAG ADJUSTMENT

All Orra™ low profile reels deliver smooth and reliable drag tension. Control the amount of

drag by turning the adjustment star inside the reel handle. Rotate the star clockwise (right) to

increase drag or counterclockwise (left) to decrease drag. For best results the drag should be

adjusted to approximately one-third of the breaking test of the line being used. This can be

accomplished by tying the line to a spring scale for precise adjustment. Make sure the reel is

first mounted on a rod and the line has been run though the rod guides before tying to the scale.

The drag should always release before the line reaches its breaking point. Factors such as line

type, technique and fishing conditions may require adjustment to these recommendations. Any

drag setting above half of the line strength risks line breakage.

If a spring scale is unavailable, tie the line to a secure point. With the rod tip up (about a 45

degree vertical angle), apply pressure by turning the handle. Gradually tighten the drag

adjustment star by rotating it clockwise. When the line reaches its breaking point, loosen the

adjustment star ¼ turn.

F. SPOOL TENSION KNOB