Duke FLM200 Anleitungsblatt - Seite 4

Blättern Sie online oder laden Sie pdf Anleitungsblatt für Kommerzielle Lebensmittelausrüstung Duke FLM200 herunter. Duke FLM200 8 Seiten.

Installation and Operation of: Product Name

REMOVAL OF EXISTING LIGHT/GASKET - cont.

Remove the inner cap inside bread display next

to the hot food unit.

Note: This will expose the bolts going

through the glass.

Using a Phillips screw driver and a 7/16" wrench

or socket remove the bolts through the glass.

Carefully slide unit out.

Remove the top cap from the door side at top

by removing the three screws.

Determine which side needs the lights replaced.

Note: if opposite side of hot food well

then repeat steps 5 and 6.

Remove the two screws on the bottom of the

counter top that are fastening the front glass to

the counter top.

Remove Screws

There will be a wire connected to the light that

must be pulled completely out of the cabinet.

Carefully lift the bottom of the front glass high

enough to allow removal of the wire (approximately

2"-3") then set back down in place once wires are

removed

Glass is not completely secured.

Remove the side glass from the cabinet and

remove the original gasket and light from the

glass, which should still be attached with adhesive.

A putty knife will work best for scraping the

adhesive away from the glass. Be careful not to

scratch or damage the glass.

Once the gasket and adhesive are removed,

thoroughly clean the glass with isopropyl

alcohol or acetone until all adhesive residue is

removed. Set the side glass aside in a safe area so it

does not get damaged until later steps.

If needed, repeat steps 5, 6, 9, 10, 11, 12,and 13

for opposite site.

Lift

Front