Duke 59 Series Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Backofen Duke 59 Series herunter. Duke 59 Series 20 Seiten. Ovens with “zp” control panel
Auch für Duke 59 Series: Installations- und Betriebshandbuch (20 seiten)
Seite drucken
E. Oven Assembly
Before assembling and installing the oven, please check
to make sure that all necessary parts are present. In
addition to the oven itself, there will also be legs, feet or
casters. (For double sections, retaining clips, flue
connector and miscellaneous hardware.) Please check
the interior of all oven sections for the parts needed to
assemble and install your oven(s).
F. Leg Attachment
Once the oven has been removed from the
•
carton, lay it on its left side (the side
without the controls).
Hold the leg and align with the matching
•
holes in base and leg flange. Carefully
start the 5/16-18 bolts, (avoid cross-
threading), by turning clockwise and
tighten to the nearest full turn. A total of
(12) 5/ 16-18 x 3/4 bolts, flat washers and
lock washers are required to secure all
legs.
Once legs are secured, add two (2) storage
•
shelves between the four (4) legs. Secure
these by using the 1/4-20 x 3/4 self-
threading
screws.
carefully lift the oven to an upright
position.
To level the unit, raise or lower the adjustable feet as
required.
G. Caster Installation
Casters are available as an option for
•
double oven sections. They are packed
inside the oven for shipment.
To install follow same procedures as for
•
leg attachment. Position and secure the
casters to the four (4) insert nuts in the
base bottom.
They have 1/2-13 threads and will only fit
NOTE:
the large insert nuts in the bottom. The two
locking casters should be installed on the front
legs for easy access and better stability.
H. Double Sections
The necessary short legs, storage shelves and hardware
are shipped with these sections. Follow same
procedures for leg attachment as described above.
Once legs and shelves are in place and the oven is
placed in an upright position install the stacking
brackets that secure the top oven to the bottom oven.
The stacking brackets mount at the rear corners of each
After
completion
4
section. Remove the screws from the corner of the
oven that matches the holes in the stacking brackets.
Install the brackets with the new screws provided.
I. Adjustments Associated with
Installation
Each oven section and all its component parts have
been tested thoroughly and inspected before your oven
was shipped from the factory. However, it is sometimes
necessary to further test or adjust the oven once it has
been installed. Such adjustments are the responsibility
of the Dealer or Installer. These types of adjustments
are not considered defects, rather a normal and routine
part of the proper installation of the equipment.
These adjustments include but are not limited to:
adjustments and recalibration of the
•
thermostat
adjustment to the doors, leveling
•
and tightening of fasteners.
•
Note: No installation should be considered
complete without proper inspection and, if
necessary, any adjustments by qualified service
or installation personnel.