Duluth Forge FVFLC30-1 Installationsanleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Innenkamin Duluth Forge FVFLC30-1 herunter. Duluth Forge FVFLC30-1 8 Seiten. Vent-free gas logs

Seite drucken

Proper Log Placement

Log placement is critical to proper burner

performance. Logs must be correctly posi-

tioned onto the burner. The illustrations in this

manual show the proper pinned position for

logs on this set. Owners need to be shown

proper log placement and instructed not to

move the logs.

Logs must fit firmly onto the burner when

positioned as shown in the illustrations.

Malformed logs or logs with sloppy pin holes

must be replaced.

Proper Primary Airflow into the

Burner

For proper burner operation and flame ap-

pearance, the flow of primary air into the

venturi tube, located on the rear of the burner,

must not be reduced. This flow of air is re-

duced if dirt, lint or other obstructions build-up

around or inside the venturi. Any obstruction

in the venturi tube area must be removed.

The flow of air into the venturi is also reduced

if the gas orifice isn't centered in the venturi

inlet and/or is not aligned with the venturi. Any

misalignment of the burner orifice may be cor-

rected by bending the shutter cap holding the

orifice to the inlet or the venturi tube.

Ceiling Fans, Portable Fans or Logs

Installed Near Cold Air Returns

Ceiling fans or oscillating floor type fans need

to be monitored during the operation of vent-

free logs. If the air blows directly into the flame

causing it to impinge on the log set, or firebox,

it should be turned off or redirected. Ceiling

fans could be reversed to possibly eliminate

flame impingement, and the floor fan could be

redirected. Upon installation, be aware of any

cold air returns or vents in the proximity of the

log set. Any draft created around a vent-free

log set can cause the flame to impinge on the

log and create a sooting situation.

200274-01C

INSTALLATION GUIDELINES

www.factorybuysdirect.com

Candles

Avoid the use of scented or decorative can-

dles while the log set is in operation. Candles

produce a residue in the air that creates a soot

like substance. Burning candles while the

log set is operating magnifies the problem.

It should be noted that candles, in general,

produce soot. The amount of time burned and

the quantity of candles burned will determine

the amount of soot produced and deposited.

Proper Log Set Operation

Properly installed and properly maintained log

sets do not deposit soot on the logs. If users

see soot appear on a log, call for service. Do

not continue to operate the log set.

Sunken Fireplace

If installing this unit into a sunken fireplace,

you must raise the floor to insure adequate

airflow and guard against sooting. Raise fire-

place floor using a noncombustible material,

which is secure.

Glass Doors

Make sure that glass doors are open during

all operations of the log set. The opening of

the glass door frame should be the dimen-

sion used for the minimum front opening of

the firebox.

Wood Burning Fireplaces

The interior of the firebox and the chimney

should be cleaned and free of all creosote be-

fore installing a gas burning log set. Creosote

will soften when heated and can drop on the

log set causing odors and possibly sooting.