Aoi Electrical AOI0011 Installationshandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör für Kraftfahrzeuge Aoi Electrical AOI0011 herunter. Aoi Electrical AOI0011 6 Seiten. Air bag control system 2004- 2009 dodge durango 2004-2012 ford crown vic 2004-2009 ford f150 2003-2010 ford explorer

Seite drucken

NOTE:

In the event the light comes back on, or you have no check light at all, DO NOT ATTEMPT TO

INSTALL THE AIR BAG SWITCH. The vehicle needs to be taken to your local service department

to have the air bag system repaired.

B. If the air bag system completes its self-testing procedure and extinguishes, as described above, the

system is working properly. You may now proceed with the installation process

IV. Air Bag Switch Installation.

A. Disconnect the vehicle battery power and allow sufficient drain time (20 Min.) for the SRS System.

B. Remove necessary trim panels, glove box, and/or support members to gain access to the Air Bag

Module.

C. Identifying Air Bag Connector type.

NOTE: There are two possible installation scenarios for this switch application.

1. With an OEM "In-line" Connector between the Air Bag Control

Module and the Air Bag Canister this would be a direct "Plug-N-Play"

2. Without an OEM In-line Connector, only control wires from the Air Bag Control

Module to the Air Bag Canister, via a "Squib" Connector.

V. Installing the Switch with an In-line Connector

A. Locate the In-Line air bag plug for the corresponding air bag, disconnect the factory plug and insert the

proper plug ends from the AOI Electrical Switch into the factory air bag plugs.

WARNING:

At NO TIME, while the air bag circuit is unplugged, should the ignition be turned ON.

B. The Air Bag Switch Harness is equipped with a Red Power Lead and Black Ground Lead. These are

used to provide the electrical power for the L.E.D. lights on the switch. Locate a convenient power

source, whether from a continuous circuit or an ignition-controlled circuit, to provide the needed power.

Contained in the kit is a Ring Terminal. This can be utilized to make your Ground connection to a

convenient screw or bolt that makes contact with the chassis.

C. Proceed to Sec. VII.

aoielectrical.com

800.480.6680