cashco 345 Handbuch für Installation, Betrieb und Wartung - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch für Installation, Betrieb und Wartung für Controller cashco 345 herunter. cashco 345 8 Seiten. Pressure reducing regulator
Seite drucken
11. Bench test unit for suitable operation. NOTE:
Regu la tors are not tight shutoff devices. Even if
pressure builds up beyond set point, a regu la tor
may or may not de velop bubble tight shutoff. In
general, tighter shutoff can be expected with
com po si tion seat.
12. Soap test around body cap (5) and body(1) for
leak age. Test pressure should be a minimum
of 100 psig (6.9 Barg) at the inlet and leakage
de ter mined by bubbles.
D. Trim Replacement (For TFE Seated Units):
1. Follow same steps as listed under trim re place ment
for metal seated units, except for the fol low ing
guidelines:
a. After removing the body cap(5) (C.2), inspect
the inside surface of the body cap for scratches
or nicks. These could result in leakage past the
quad ring (19) and backup ring (20). If worn
or scratched replace the body cap (5).
b. When inspecting parts for excessive wear
(C.3), assure there are no foreign particles
embedded in the teflon seat. Inspect for nicks.
Inspect the backup ring (20) and quad ring (19)
on piston post.
Vll. TROUBLE SHOOTING GUIDE
1. Erratic operation.
A.
Oversized regulator; inadequate rangeability.
B.
Worn piston/cylinder; inadequate guiding.
C.
Weakened/broken piston spring.
2. Sluggish operation.
A.
Plugged piston balance port.
B.
Fluid too viscous.
4
Possible Causes
Possible Causes
c. Remove the body cap o-ring (13) and clean
con tact ing sur face of body.
2. To check for seat leakage, follow same steps as
listed under Pressure Piston/O-ring Inspection/
Replacement, except for the following guide lines:
a. Pour a small amount of water in on top of the
piston (through pressure piston bore in body).
Crack open inlet pressure (50 psig maximum)
to body and visu ally check for leakage by the
cylinder gasket (18), TFE seat (15), or the body
quad ring (19). After inspection, assure that
water is removed before completing assembly
and installing in line.
NOTE: When piston (15) assemblies are used with comp
seats, Cashco, Inc. does not recom mend attempting to
remove the comp seat. If composition seat is damaged,
replace entire piston assembly.
SECTION VII
A1. Check actual flow conditions, re-size regulator for minimum and
maximum flow.
A2. Increase flow rate.
A3. Decrease regulator pressure drop; decrease inlet pressure by
placing a throttling orifi ce in inlet piping union.
A4. Install next step higher range spring.
A5. Before replacing regulator contact factory
B.
Replace trim.
C.
Replace piston spring.
A.
Remove trim and clean balance port.
B.
Heat fluid. Contact factory.
Remedies
Remedies
IOM-345