Duncan Vapor Trail Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musik-Pedal Duncan Vapor Trail herunter. Duncan Vapor Trail 12 Seiten. Analog delay pedal

g e T T I n g S T A R T e d !

1. Put a fresh 9v battery in, or plug in any 9v regulated DC power supply with a negative

polarity center terminal.

2. Run good quality, unbalanced, shielded guitar cables from your guitar to the input jack, and

from the output jack to your amp's input or to the next pedal on your pedal board.

3. Start with the Mix, Repeats and Delay knobs at 12 o'clock and the Rate and Depth knobs

fully counter-clockwise (no modulation). Set your amp level appropriately.

4. Engage the Vapor Trail Analog Delay by pressing the footswitch – the LED will come on

when it's active.

5. Set the Mix knob to a setting that gives you the balance you want between original dry

signal and delay effect, then start experimenting with the controls. If you want to control the

Wet/Dry mix with an expression pedal, plug the pedal into the Insert jack, crank the Mix up

to full, and vary the mix with the pedal. Try different combinations of Delay time and Repeats

settings, then start dialing in some modulation using the Rate and Depth controls. You won't

hear any modulation effect until the Depth control is brought up. Different Rate settings

will also affect how much or how little of the modulation effect you can hear, so have fun

experimenting!

S A M P L e S e T T I n g S

The Vapor Trail Analog Delay can produce a dizzying array of effects from subtle shimmer to

alien invasion. These settings are just a few examples of what this unit can do.