Duncan BLACKOUTS AHB-1 Stromlaufplan

Blättern Sie online oder laden Sie pdf Stromlaufplan für Zubehör für Musikinstrumente Duncan BLACKOUTS AHB-1 herunter. Duncan BLACKOUTS AHB-1 2 Seiten.

Seite drucken

Wiring Diagram for

Pickup Models:

BLACKOUTS

AHB-1 Active Humbuckers

All 6 and 7 string models

MICK THOMSON / EMTY

SIGNATURE BLACKOUTS

AHB-3 MickT Blackouts

LIVE WIRE

CLASSIC II HUMBUCKER

Active System Guitar Pickups

5427 hollister avenue, santa barbara, ca 93111

tel 805.964.9610 fax 805.964.9749

www.seymourduncan.com

2 Volumes, 2 Tones

Seymour Duncan

Congratulations on your purchase of a fine, hand-built, Seymour Duncan electric guitar pickup! Installing

this pickup in your guitar isn't rocket science. And, if you're already handy with tools, it'll be a snap for

you–and fun too! But if you have no experience handling red-hot soldering irons, you'd be well advised

to take your new pickup and your trusty guitar to a qualified guitar tech.

The basic installation steps include:

1. Remove the strings from your guitar.

2. Remove the pickguard, or mounting ring, and control plate cover from your guitar.

3. De-solder the original pickup's wires and be sure to remember where they were

connected.

4. Remove the original pickup from the pickguard or mounting ring.

5. Install the Seymour Duncan pickup into the pickguard or mounting ring.

6. If your original pickups were passive, remove the original pots and output jack,

and replace them with the provided 25k pots and stereo output jack.

7. Install the new 25k pots and stereo jack, and connect them as shown, depending

on your control set up. If your guitar is already equipped with 25k pots,

and has active pickups with quick connector cables, then you can simply unplug

the original active pickup from the quick connector, and plug in your new

active Blackout using the quick connector plug that is located on the bottom of

each Blackout.

8. Tin the wires from your Seymour Duncan pickup, and then solder them in place

9. Connect the red wires from all pickups to the red wire from the battery clip.

10. Connect the black wire from the battery clip to the ring terminal of the

output jack.

11. Re-attach the pickguard or mounting ring to the top of the guitar, and replace any

control panel plates.

12. Re-string your guitar and adjust the pickup height so that your pickups balance

with one another. The bridge pickup should be between 1/8" and 1/16" from the

strings when they are pressed down at the highest fret---then adjust the neck (or

neck and middle) pickups to get an even output balance.

LONG SHAFT POTS ARE AVAILABLE

If you have a guitar that requires long-

shaft potentiometers we will gladly send

you four long-shaft pots (with all of the

nuts & washers) free of charge.:

U.S. CUSTOMERS

email your shipping address to:

[email protected]

or call (805) 964-9610 ext 501

NON U.S. CUSTOMERS

Visit our website to obtain the contact info

for the Seymour Duncan distributor in your

part of the world: seymourduncan.com.

Using the quick connector system