CASI RUSCO 660 Installationshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Installationshandbuch für Tastenfeld CASI RUSCO 660 herunter. CASI RUSCO 660 14 Seiten.

Programming the Keypad

Current Model Keypad: This keypad is capable of having the site code

programmed in the field. The PINK wire is used in this procedure. With

no voltage applied to the keypad, connect the PINK wire to the BLACK

wire on the wiring harness. Apply the appropriate voltage to the RED

and BLACK wires. You will hear 4 rapid audible beeps and both the RED

and the GREEN LEDs will flash at the same rate. Enter the desired site

code (between 001 and 255) on the keypad and press # for enter. (The site

code MUST be 3 digits only and 000 is not an acceptable site code. Site

code 00001 would be entered as "001"; 00123 would be entered as "123".)

You will again hear 4 rapid audible beeps and see both LEDs flash 4

times. At this point, the keypad will appear dead and will not accept any

entries.

If a wrong key is pressed during the programming experience, pressing

the * key will clear the entry. You will hear 2 rapid beeps and both LEDs

will flash at the same rate. (The keypad will generate a long error tone if

you enter a site code over 255.)

Disconnect power to the RED wire and disconnect the PINK wire from

the BLACK wire. Now, you can connect the standard Wiegand 5 wires to

the Keypad and the programmed site code will be generated as part of

the 26-bit data when the enter key (#) is pressed.

This procedure may be repeated to change the site code. Factory default

is 000.

NOTE: If you have an older Model 660 Keypad (YELLOW wire), it has been

preprogrammed with the site codes "0000" and "0001." Leaving the yellow

wire disconnected results in a site code of "0000." Connecting the yellow

wire to the black wire (ground) results in a site code of "0001."

Model 660 Keypad