Danfoss DEVIreg 610 Installationshandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Installationshandbuch für Thermostat Danfoss DEVIreg 610 herunter. Danfoss DEVIreg 610 16 Seiten. Electronic thermostat
Auch für Danfoss DEVIreg 610: Installationshandbuch (12 seiten), Installationshandbuch (16 seiten)
Seite drucken
DEVIreg™ 610
The screen of the heating cable must be connected to
the earth conductor of the power supply cable by using
a separate connector.
4.
Reinstall the front cover.
5.
Ensure that the adjustment button can be adjusted
within full temperature range, i.e. from -10 °C to
+50 °C.
6.
Install sensor using the supplied sensor cable - spec.
NTC 15 kΩ @ 25°C.
• Press out the blanket located at the bottom of the
thermostat and insert the seal nipple.
• Connect sensor to terminals 6+7.
The sensor cable can be extended up to 50 m with
1,5 mm² installation cable without affecting the
accuracy of the thermostat.
Do not place the cable parallel to other installation
cables as undesirable signals may be induced.
The installation must be permanent.
If the sensor is to be built in, used for pipe
applications, or exposed to pressure, always install it
in a conduit.
7.
Turn on the power supply.
Installation Guide
9