Danfoss ECL Comfort 296 Betriebshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Thermostat Danfoss ECL Comfort 296 herunter. Danfoss ECL Comfort 296 16 Seiten. Return temperature limitation
Auch für Danfoss ECL Comfort 296: Benutzerhandbuch (12 seiten), Installationshandbuch (20 seiten), Service-Handbuch (16 seiten), Betriebshandbuch (8 seiten), Betriebshandbuch (10 seiten), Installationshandbuch (16 seiten), Installationshandbuch (16 seiten), Installationshandbuch (16 seiten), Installationshandbuch (20 seiten), Installationshandbuch (12 seiten), Installationshandbuch (16 seiten), Betriebshandbuch (8 seiten)

ECL Comfort 210 / 296 / 310, Floor (Screed) Drying Program

Prog. execution (Program execution)

Start or stop the floor drying process.

Press and hold the dial for 5 seconds in order to start or stop the

process.

OFF:

The floor drying process is not active

ON:

The floor drying process is active

Max. pwr. failure (Max. power failure period

acceptance)

Setting the max. accepted time for power failure.

If the ECL Comfort controller is without power for more than the set

time, the alarm will be activated when the controller is powered up.

Value: Set the accepted time

The alarm can be reset (MENU > Alarm > Alarm overview)

To restart the floor drying process:

If the parameter "After power fail." (ID 10913) is set to STOP, the

"Prog. execution" must be set to OFF and then to ON.

VI.JM.P2.02

10512

If the ECL Comfort controller is set to manual mode, the floor drying

process can be started, but will not be active.

If "Prog. execution" is set to ON and returns to OFF after 5 seconds,

none of the circuits in the graph (Desired flow T) have been selected

for floor drying.

If the parameter "Appl. continue" (ID 10912) is set to STOP, the "Prog.

execution" remains ON after elapse of the floor drying process.

10514

After a power failure, the alarm is indicated / activated.

If the parameter "After power fail." (ID 10913) is set to STOP, the desired

flow temperature is maintained at the value, set in X1.