Danfoss 176F4060 Installationshandbuch - Seite 13

Blättern Sie online oder laden Sie pdf Installationshandbuch für Medienkonverter Danfoss 176F4060 herunter. Danfoss 176F4060 16 Seiten. In-bottom/out-back cooling kit for fa11-fa12, frequency converters

Seite drucken
Danfoss 176F4060 Installationshandbuch
In-bottom/Out-back Cooling Kit for FA11-FA12
Installation Guide
2.8 Installing the Base Plate and Bottom Duct
To attach the bottom duct to the base plate of the cabinet, use the following steps. Refer to
Procedure
1.
Remove the base plate from the Rittal cabinet and replace it with the base plate from the kit, which has a vent opening for
the bottom duct.
2.
Position the bottom duct over the vent opening in the base plate.
3.
Place the holes in the lower flange of the duct over the 6 threaded studs surrounding the opening in the base plate.
4.
Fasten 6 M5 hex nuts (T25) to the threaded studs.
5.
Collapse the duct and install the base plate between the pedestal and the cabinet frame using the existing fasteners.
1
2
3
Illustration 11: Installation of the Bottom Duct on the Base Plate
1
Base plate (with opening for duct)
2
Bottom duct assembly
3
Lower flange of duct

2.9 Mounting the Frequency Converter

To install the mounting plate and frequency converter in the cabinet, use the following steps. Refer to
Procedure
1.
Remove the paper backing from both 6-hole gaskets, exposing the adhesive.
2.
Adhere 1 gasket around the vent opening on each side of the mounting plate.
3.
Position the mounting plate in the Rittal cabinet, aligning the top mounting plate hole with the 5
cabinet rails.
Check that the pem nuts face the back of the cabinet.
4.
Fasten the mounting plate to the cabinet rails with 14 M5x10 thread-forming screws.
5.
Loosely fasten 3 M10 screws (not supplied) into the pem nuts at the lower end of the mounting plate.
Check that the screws are secure. The base of the frequency converter rests on the screws.
6.
Slightly lean the top of the frequency converter forward and set the cutouts in the base onto the 3 screws.
7.
Slowly push the top of the frequency converter back against the mounting plate until the top 3 pem nuts line up with the
holes in the frequency converter.
Danfoss A/S © 2022.12
Illustration
4
M5x18 screw
5
M5 hex nut
6
Threaded stud
AN361429392581en-000201 / 136R0253 | 13
Installation
11.
4
5
6
Illustration
12.
th
hole from the top of the