Danfoss iC7 Series Installationshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Installationshandbuch für Medienkonverter Danfoss iC7 Series herunter. Danfoss iC7 Series 8 Seiten. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Auch für Danfoss iC7 Series: Installationshandbuch (8 seiten), Installationshandbuch (6 seiten), Installationshandbuch (14 seiten), Installationshandbuch (16 seiten), Installationshandbuch (8 seiten), Installationshandbuch (8 seiten), Installationshandbuch (10 seiten), Installationshandbuch (16 seiten), Installationshandbuch (16 seiten), Installationshandbuch (6 seiten), Installationshandbuch (6 seiten), Installationshandbuch (16 seiten), Installationshandbuch (18 seiten)

Seite drucken
Danfoss iC7 Series Installationshandbuch
SCR/Diode Module Replacement for Fx09-Fx12/D1h–D8h/E1h–E4h
Installation Guide
1
2
Illustration 1: SCR/Diode Module Thermal Grease Pattern
1
Bottom surface of SCR/diode module
2
Thermal grease
4.
Place the module on the heat sink, and twist it back and forth to spread the thermal grease evenly on the SCR/diode mod-
ule and the heat sink surface.
5.
Align the mounting holes in the SCR/diode module with the holes in the heat sink.
6.
Insert the screws into the SCR/diode modules and hand tighten them.
7.
Wait 1 minute.
8.
Using a manual torque wrench to avoid over torquing the screws, follow the tightening sequence shown in
Apply 0.6 Nm (5.3 in-lb) of initial torque at a maximum of 100 RPM. Then apply final torque in the same sequence using
the values listed in
9.
Connect the gate lead to the cable connector on the SCR/diode module.
For SCR/diode module conversion kits, continue to
kit. Otherwise, complete the frequency converter reassembly as described in the service guide.
Danfoss A/S © 2022.07
Table
7.
2.3 Installing the SCR/Diode Module Busbars
Installation
Illustration
to install the rest of the
AN334838812834en-000201 / 130R0771 | 5
2.