Free The Tone AS-1R Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Aufnahmegeräte Free The Tone AS-1R herunter. Free The Tone AS-1R 8 Seiten. Digital reverb

Seite drucken

Switching 1-128 presets via MIDI

1. Connect an external MIDI controller to the MIDI IN terminal on the AMBI SPACE rear panel.

2. Press the effect ON/OFF switch to illuminate the LED above it.

3. From the external MIDI controller, send the MIDI program change number corresponding to the preset to be

recalled.

NOTE

Be sure to set the same MIDI program change number on the sending device's MIDI channel and the AMBI SPACE

MIDI channel.

Setting up MIDI Receiving Channel P10.

Correspondence between MIDI receiving channels and PRESET LED indications P11.

Confirming the position of each knob stored in the preset

1. Recall the desired preset.

2. Press the EDIT switch. The PRESET LED for the selected preset flashes.

3. urn the desired knob clockwise or counterclockwise to confirm its stored position in the preset. The stored

knob position is indicated by the PRESET 1–4 LEDs as shown in the note below.

NOTE

The PRESET 1 LED illuminates: The knob is moving in the counterclockwise direction comparing its current

position with the position stored in the preset.

The PRESET 4 LED illuminates: The knob is moving in the clockwise direction comparing its current position with

the position stored in the preset.

The PRESET 2 and PRESET 3 LEDs illuminate: The knob is at the same position as stored in the preset.

Changing/writing preset contents (Edit mode)

When the LED above the EDIT switch illuminates, the AMBI SPACE is in Edit mode. Edit mode is used to

change/write preset contents and pressing the EDIT switch puts the AMBI SPACE in this mode.

When the unit is put in Edit mode from Manual mode

The current Manual mode setting is written to the preset.

1. Press the EDIT switch to enter into Edit mode.

2. Turn the knob of the parameter you want to change.

3. To select the preset for saving the settings, press the PRESET switch (preset 1–4) or send the MIDI program

change number corresponding to the desired preset number (preset 1–128) from the external MIDI device.

4. Press and hold the EDIT switch for 1.5 secs., the EDIT LED will flash and the writing operation will be executed.

After writing, the contents of that preset number are recalled and the

NOTE

By pressing the EDIT switch again after turning the knobs to change parameters in Edit mode, your changes

are canceled and the AMBI SPACE returns to the status in which the original preset is recalled.

When the unit is put in Edit mode from Preset mode

You can adjust only the desired parameters of the current preset sound and store them in the preset.

1. Press the EDIT switch to enter into Edit mode.

2. Turn the knob of the parameter you want to change.

3. To select the preset for saving the settings, press the PRESET switch (preset 1–4) or send the MIDI program change

number corresponding to the desired preset number (preset 1–128) from the external MIDI device.

4. Press and hold the EDIT switch for 1.5 secs., the EDIT LED will flash and the writing operation will be executed.

After writing, the contents of that preset number are recalled.

NOTE

By pressing the EDIT switch again after turning the knobs to change parameters in Edit mode, your changes

are canceled and the AMBI SPACE returns to the status in which the original preset is recalled.

AMBI SPACE

enters Preset mode.