Duomo BX308 XP Schnellstart-Handbuch - Seite 5
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Controller Duomo BX308 XP herunter. Duomo BX308 XP 17 Seiten. 8 sensor gas detection controller
Seite druckenBX308 XP Gas Detection Controller
Precautions
TERMS & EXPECTATIONS:
BX308xp guaranteed by the manufacturer, must be carried out by authorised and capable personnel.
Be sure to disconnect the controller from the power supply before making changes to the connections. After making
all the connections and configurations, the system can be powered up
Check the integrity of the sensor after having removed it from the box.
Check that the power supply to be supplied to the appliance is compatible with the limits illustrated above. When doing
the electrical connections, follow the drawing closely.
Any use of the detector for purposes other than the intended one is considered improper, and as a result of which
Duomo (UK) therefore disclaims any responsibility for possible damages caused to people, animals or objects.
IMPORTANT: Function testing should be carried out with calibrated test gas to ensure sufficient and safe gas
concentration to activate the main alarm.
WARNING!
•
This control unit is NOT built for installation in ATEX classified areas
•
To meet the requirements as a control unit according to the standard EN 60079-29-1: 2016
•
Duomo (UK) has relied on programming and functions via a microprocessor with a numeric alpha display
•
All the wiring of the remote sensors must be made using wires with a minimum section of 1.5 mm2 and no
longer than 100m. Do not use the same conduit for signal and power cables.
•
If strong EMC disturbances are present the use of shielded cables is strongly recommended. The screen must
be connected to the 'Gnd' terminal of the interested area only on the side of the control unit.
•
The appliance must be connected to the power supply by means of a switch capable of disconnecting the poles
in compliance with current safety standards and with a contact.
•
separation of at least 3 mm in all poles.
•
The installation and electrical connections of this appliance must be carried out by qualified personnel.
•
technicians and in compliance with the current technical and safety standards.
•
Be sure to turn off the power before wiring the device.
•
Safety depends on the installer (whose responsibility is to set up a detection system in compliance with existing
standards, both European and national) to choose the correct type of loads to be connected to the control unit
and the correct configuration of the system parameters.
•
In case of doubt, please contact the distributor.
Keep in mind the following precautions to keep the BX308xp in good working order
•
Do not allow it to become wet.
•
The control unit is not waterproof if immersed in water or exposed to high humidity, it can be seriously damaged.
•
Do not drop it.
•
Heavy knocks or falls during transportation or installation can damage the appliance.
•
Avoid abrupt temperature fluctuations.
•
Sudden temperature variations can cause condensation and the probe could work poorly.
•
Never clean the device with chemical products. If necessary, wash with a moist cloth.
t: 01905 797989
e: [email protected] | w: www.duomo.co.uk
The installation, service and removal at the end of its functional life of the
5