AudioControl LC7i PRO Schnellstart-Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Computer Hardware AudioControl LC7i PRO herunter. AudioControl LC7i PRO 13 Seiten.

Setting AccuBASS®

AccuBASS is a feature that restores bass frequencies on factory systems that

roll off the bass as you increase volume. If you can hear that the bass does not

increase as you continue to turn up the volume on the head unit, then your

factory system is most likely rolling off bass.

AccuBASS only affects the Channel 3 outputs.

There are two AccuBASS controls and a status LED used during initial setup:

AccuBASS Threshold determines when AccuBASS turns on, and AccuBASS

Level adjusts how much bass is restored. The status LED will illuminate when

AccuBASS is active.

1. Turn AccuBASS Threshold all the way down

(counterclockwise).

2. Set AccuBASS Level at the 12 o'clock position.

3. Play some bass-heavy music you are familiar with.

4. Slowly turn up head unit volume until you start to hear bass dropping

out (roll off ). Stop turning up the head unit volume.

5. Slowly turn AccuBASS Threshold to the right (clockwise) until the status

LED illuminates and you hear bass being restored. Stop adjusting

AccuBASS Threshold.

6. With AccuBASS Threshold set you can now adjust AccuBASS Level to your

liking.

If the sound system in your vehicle does not reduce bass output at higher

volumes, AccuBASS may be defeated, or used without the threshold setting

(on all of the time). To defeat (turn off ) AccuBASS, turn AccuBASS Threshold all

the way down (counterclockwise), and turn AccuBASS Level all the way down

(counterclockwise).

To keep AccuBASS on all of the time so it does not turn on/off at a set

threshold, turn AccuBASS Threshold all the way up (clockwise). Now,

regardless of the head unit volume, AccuBASS will always be on. Adjust

AccuBASS Level to your liking.

ACR-1 Dash Control

The ACR-1 dash control may be mounted under the dash using its own

bracket or custom mounted in the dash (or anywhere else). It should be within

reach of the driver and in a spot where the LED is plainly visible.

Bracket Installation

Slide under the dash and place the dash control in the desired position, mark

the two mounting holes, drill pilot holes and secure with two screws.

Custom Installation

Remove the dash control from the mounting bracket by pushing the LED

from its holder and then removing the circuit board and rotary control from

the bracket. Choose a suitable location and drill a 9/32" hole for the control

shaft along with a 1/8" hole for the lock tab and a 13/64" hole for the LED

holder. Reassemble the ACR-1 components in their new custom location.