Daniamant Echopilot FLS 3D Handbuch - Seite 15

Blättern Sie online oder laden Sie pdf Handbuch für Sonar Daniamant Echopilot FLS 3D herunter. Daniamant Echopilot FLS 3D 17 Seiten. Forward looking sonar

Seite drucken

Industrivej 24C

DK-3550 Slangerup

Denmark

FLS 3D

Tel. +45 4737 3800

Fax: +45 4737 3809

[email protected]

www.daniamant.com

7. Fault Finding

Some Common Faults

Display doesn't switch on (no display):

· Battery not connected

· Battery voltage too low

My 3D has no coms. (red cross):

· Check that the coms port is set to com1 (within menu)

· Check power to the transducer interface

· Check com cable

Poor seabed picture or excessive noise:

· Suitable range not selected (try to fill screen with seabed)

· Poor connection of transducer

· Battery voltage low - use Test Mode to check Tx voltage

· Transducer mounted at an angle

· Turbulence at transducer location

· Interference from other 200KHz sounders (same boat or other boats)

· Turbulence/wake from other boats

· Polluted water or Plankton bloom (usually early summer)

· Dirty transducer/covered with barnacles

· Choppy sea state - can cause surface noise

FLS 3D Manual Version 1

Daniamant A/S