Audiolab M-PWR Gebrauchsanweisung - Seite 5

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Verstärken Audiolab M-PWR herunter. Audiolab M-PWR 13 Seiten.
Auch für Audiolab M-PWR: Gebrauchsanweisung (12 seiten)

Seite drucken

4: Connections-1

You should read the following useful notes carefully before you begin to install

and use the equipment.

There are no user adjustable parts inside the equipment. You should refer to a

qualified engineer or return the equipment to either the dealer or the Audiolab

distributor for any servicing requirements.

Important notice: Please do not connect loudspeakers or source components

to the amplifier when switched on. Always switch M-PWR off before making

connections!

The Audiolab M-PWR Stereo Amplifier will be warm when running, the actual

temperature depending on the power output. A resettable current trip will

automatically switch the amplifier off under gross overload or short circuit

output etc. The fins of the heat sink should be kept clear of obstruction to allow

adequate ventilation in normal use.

Checking the AC power supply

The Audiolab M-PWR Stereo Amplifier is supplied in four versions suitable

for connection to 240V, 230V, 115V or 100V AC power supplies. Before

connecting the amplifier check that you have the correct version. If the

amplifier is connected to a lower voltage than marked, the maximum output

power will be lower than specified.

Please check with the dealer if you have any doubt as to the voltage in your

area or intend to use the equipment in regions which use different mains

voltages. If you are in any doubt of the correct operational voltage, ask a

qualified electrician before applying power to the equipment. The Audiolab

M-PWR Amplifier will work correctly within standard tolerances of this voltage.

Audiolab M-PWR english manual.in5

Fuse

The mains supply fuse of Audiolab M-PWR Stereo Amplifier is accessible on

the rear panel after the IEC mains plug has been removed. In the rare event

that the amplifier stops operating, you should first check for any obvious cause

before replacing the fuse with one of the correct rating and type. The correct

fuse values are:

220 - 240V (UK, EU, Korea, etc.) T2AL 20mm Slow Blow

100 - 120V (USA, Japan, etc.) T3.15AL 20mm Slow Blow

You should switch off the equipment and remove the connection to the mains

power outlet before changing the fuse.

Connecting to the AC power supply

The Audiolab M-PWR Stereo Amplifier is provided with a mains cable fitted

with an appropriate mains plug. This plug should not be cut from the cable. If

for any reason, the plug is removed it must be safely disposed. It must never be

plugged into a mains outlet.

Page 4

2013-3-11

12:29:03