Audiolab 6000CDT Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für CD-Spieler Audiolab 6000CDT herunter. Audiolab 6000CDT 13 Seiten.
Auch für Audiolab 6000CDT: Gebrauchsanweisung (13 seiten)

Seite drucken
5: Connections
Digital Outputs
Coaxial and Optical output
One Coaxial and one Optical SPDIF digital output. Connect a
suitable Digital coaxial (fully screened) interconnect or optical
cable from the appropriate SPDIF output of the 6000CDT to
the input of a DAC or digital input on your amplifier or
preamplifier.
Trigger Connections
Audiolab 6000CDT has a pair of trigger connections on the rear panel that can activate 6000A's
or any other source's trigger input. If you have a 6000 system, we advise connecting the
triggers. This will enable all 6000 units to be brought in and out of standby using the trigger
connections. To connect to your control unit, you will need a cable with one end to match the
trigger output of the control unit and other terminating in a 3.5mm jack plug. For Audiolab
6000series, this will be a 3.5mm to 3.5mm interconnect.
OFF
ON
OUTPUT
RIGHT
330
OUT
6000A
IN
L
OPT1
OPT2
R
OUT
DIG1
DIG2
P
RE
AUX1
AUX2
AUX3
Mains Input
Before connecting the 6000CDT to the mains supply make sure that all the other connections to
your system have been properly and securely made. Make sure the ON/OFF switch on the
6000CDT is switched off. Switch the mains supply off at the wall socket, and then, using the cable
supplied, connect the socket on the back of your 6000CDT to an AC supply outlet. The 6000CDT
is now ready for operation.
630
Page 5