Audiolab 6000N Play Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Medienkonverter Audiolab 6000N Play herunter. Audiolab 6000N Play 20 Seiten.

7.Download the APP

Download the DTS Play-Fi APP

The DTS Play-Fi APP can be downloaded from the Google Play Store, Amazon APP Market or

Apple App Store. For Windows PC you can download the Play-Fi Windows APP from the oﬃcial

website: https://play-ﬁ.com

Network settings

Wired network setting

Connect the Ethernet Port to the LAN port of a wireless router using a suitable cable. After

switching on the 6000N, the red LED indicators on the front and rear panels will ﬂash during

the connection phase. If the connection is successful, the LED on the rear panel will go oﬀ and

the front panel LED will be brightly lit.

Wireless Network Setting

You can connect to a wireless network using one of two modes: WPS Mode or Standard Mode.

WPS Mode:

In order to make the 6000N enter WPS Mode, switch the unit on and press and hold the Wi-FI

SETUP button on the rear panel for 4 seconds. The Wi-Fi LED will double-ﬂash with a tone

indicating that WPS Mode is active. Then press the WPS key on your wireless router and the

unit should connect to your wireless network automatically. This connection phase may take

up to 60 seconds. If the connection fails, please try again.

Standard Mode:

After switching the 6000N on, press and hold the Wi-Fi SETUP button on the rear panel for 8

seconds. For the ﬁrst 4 seconds the LED will double-ﬂash with a tone - keep holding the button

down and after 8 seconds the Wi-Fi LED will ﬂash quickly with the same tone. The Standard

connection mode is now active.

When the Standard connection Wi-Fi hotspot is active the Wi-Fi LED will ﬂash-breathe with a

slow ﬂuctuation between oﬀ and on (reﬂected by the white LED on the front panel). You can

now use your Android or IOS device to enter the Wi-Fi password using the DTS Play-Fi APP as

follows (see next page):

Page 9