Conquip FA811AC-03000 Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Baumaschinen Conquip FA811AC-03000 herunter. Conquip FA811AC-03000 10 Seiten. Forklift crane arm
Seite druckenOriginal Working Instructions
Usage Instructions
Important Usage Notes
•
If you have any concerns or questions do not use the equipment; contact
your supervisor or Conquip Engineering Group.
•
The reach and angle of the jib can be adjusted to suit the operator's
requirement. Always refer to the loading chart of the operating machine.
Where the weight of the load cannot be accurately established the notional
weight must be multiplied by an appropriate factor (typically 1.5) to allow for
possible inaccuracies.
•
This equipment is designed to lift the load clear of the ground, do not drag
the load.
•
The Forklift Crane Arm is supplied with two heel pins, one for each fork
pocket. These must both be fitted correctly before use. If one or more are
damaged, incomplete or missing do not use the equipment, do not use
alternatives and contact Conquip for a replacement.
•
Suitably certified lifting equipment is to be used.
•
Under no circumstances should the crane arm be transported when the
forks are pointed towards the ground. Always lift with the forks tilted slightly
upwards.
User Guide - Forklift Crane Arm
Original Working Instructions
Usage Instructions
Using with a Forklift
1. Before using, familiarise yourself with the equipment and check that the
crane arm is in good condition with all parts present and correct.
2. To attach the Forklift Crane Arm to a forklift, first release the heel pin by
removing the linch pin and pulling from the attachment. Set the machine's
forks to the correct width for the Forklift Crane Arm fork pockets. Make sure
that they are equidistant from the centre.
3. Drive the forklift to the Forklift Crane Arm aligning the forks with the Forklift
Crane Arm fork pockets.
4. Double check that all is correctly aligned, then move the forklift forward until
the forks are fully inserted into the fork pockets.
5. Apply the park brake and switch off the forklift engine.
6. Insert the heel pin ensuring it passes behind the heel of the fork, use the
linch pin to lock the heel pin in place. The Forklift Crane Arm is now ready for
use.
7. The hook can be moved to any of the locating positions and, if necessary, the
support leg can be moved or removed to facilitate the hook position. Only
remove support leg when it is fitted to the forklift.
8. Raise and position the hook over the load ensuring that it is centrally aligned
before lowering.
9. Lower the hook and attach to the load ensuring tha the hook latch closes
fully.
10. Carefully raise the load just off the ground and check for balance and
security. Do not allow hands or feet to come between or below the load.
11. If the load is balanced and secure, carefully transport the load to its required
destination ensuring not to jolt the load. Lift with the forks tilted slightly back.
When travelling with a suspended load, keep the load as low as practicable,
keep speed and cornering to a minimum to avoid the load swinging.
12. When in position, the load can be lowered to the ground and the lifting hook
can be released and lifted clear of the load.
13. With the crane arm free of any load, lower it to the ground.
14. Disconnect the heel pins and linch pins.
15. Reverse the forklift back and clear, then replace the heel pins and linch pins.
7