Daniela DAN9MTB Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Backofen Daniela DAN9MTB herunter. Daniela DAN9MTB 11 Seiten. 60cm built in 9 function electric oven
Seite drucken
PLEASE ENSURE YOU READ THESE INSTALLATION GUIDES, RULES, TERMS AND
CONDITIONS BEFORE CALLING FOR A SERVICE. FAILURE IN DOING SO MAY RESULT
IN DAMAGES TO THE APPLIANCE AND JOINERY – CHARGES MAY BE APPLICABLE AND
WARRANTY WILL BE VOIDED.
SAFETY HINTS
•
Do not use the oven unless you are wearing something on your feet. Do not touch the oven
with wet or damp hands or feet.
•
For oven: Oven door should not be opened often during the cooking period.
•
The appliance must be installed by an authorized technician and put into use. The producer
is not responsible for any damage that might be caused by defective placement, and
installation by unauthorized personnel.
•
When the door or drawer of oven is open do not leave anything on it, you may unbalance
your appliance or break the door.
•
Some parts of appliance may keep its heat for a long time; it is required to wait for it to cool
down before touching onto the points that are exposed to the heat directly.
•
If you will not use the appliance for a long time, it is advised to plug it off.
FITTING THE OVEN INTO THE KITCHEN UNIT
Fit the oven into the space provided in the kitchen unit; it may be fitted underneath a work top
or into an upright cupboard. Fix the oven in position by screwing into place, using the two fixing
holes in the frame. To locate the fixing holes, open the oven door and look inside. To allow
adequate ventilation, the measurements and distances adhered to when fixing the oven.
IMPORTANT
•
If the oven is to work properly, the kitchen housing must be suitable. The panels of the kitchen
unit that are next to the oven must be made of a heat resistant material. Ensure that the glues
of units that are made of veneered wood can withstand temperatures of at least 120ºC.
•
Plastics or glues that cannot withstand such temperatures will melt and deform the unit,
once the oven has been lodged inside the units, electrical parts must be completely
insulated. This is a legal safety requirement.
•
All guards must be firmly fixed into place so that it is impossible to remove them without
using special tools. Remove the back of the kitchen unit to ensure an adequate current of
air circulates around the oven. The hob must have a rear gap of at least 45mm.
PA G E 6
P
I
02 9604 1226
E
I
W
|
danielaappliances.com.au
VENTILATING OPENINGS
When cooking is finished or in pause state or in waiting state, if the oven's center temperature is
INSTALLATION
over 75 degree, the cooling fan will continue working for 15 minutes. Or when the oven's center
temperature becomes lower than 75 degree, the cooling fan will stop in advance.
•
Remove all packaging, protective film and securing tape from the appliance.
•
Position the appliance in a dry atmosphere.
•
The following dimensions are provided as a guide for installation – your installer will
carry out the installation in accordance with the current regulations.
•
Your installer will connect the power cable in accordance with the current regulations.
CONNECTION OF THE OVEN
In order to ensure that the built-in appliance functions properly, the cabinet containing it
must be appropriate. The figure below gives the dimensions of the cut-out for installation
under the counter.
In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed.
The oven must have a 40mm clearance between the oven and the rear timber panel.
The panels of the adjacent cabinets must be made of heat-resistant material. In particular,
cabinets with a veneer exterior must be assembled with glues which can withstand temperatures
of up to 100ºC.
In compliance with current safety standards, contact with the electrical parts of the oven must
not be possible once it has been installed.
INSTALLATION
The oven must be secured by 4 screws to the cabinet.
G560
A595
C575
B595
Remark:
1.Only plus deviations are admissible for all dimension.
•
Only plus deviations are admissible for all dimension.
2.The cabinet is not include the power switch or socket.
•
The cabinet is not include the power switch or socket.
NOTE: The number of accessories included depends on the particular appliance purchased.
NOTE: The number of accessories included
depends on the particular appliance purchased.
12
P
I
02 9604 1226
E
I
Ventilating openings
N
L
80
250
100
E600
F570
min.
H560
D606
W
|
danielaappliances.com.au
PA G E 7