Bramley 42 AB2 Betriebsanleitung & Stückliste - Seite 3
Blättern Sie online oder laden Sie pdf Betriebsanleitung & Stückliste für Baumaschinen Bramley 42 AB2 herunter. Bramley 42 AB2 4 Seiten. Angle bending machines
Seite druckenMachines
Due to the variations between metric and imperial
bar specifications the Eccentric Block type clamp
may require shimming behind the Clamp Pad
(P6207) to achieve sufficient clamping force for
some sizes of material.
With the material to be bent secured in the Vice,
adjust the Bending Plate (P6209 / P4209) so that
it just comes in contact with the material.
By backing the Bending Plate (P6209 / P4209)
slightly off the material to be bent a larger bend
radius may be achieved.
Then by pulling on the Bending Handle (P6208 /
P4214), pull around until the desired bend angle
is achieved.
The bend angle can be limited by sliding the Limit
Stop (P6214 / P4222) around the angle quadrant
VICE GUIDE SHORT (P4217)
VICE PLATE
(P4223)
CLAMP PAD P4207
M12 X 50
CAPSCREW
(P42C1)
LIMIT STOP
BOLT (P4220)
LIMIT STOP
WASHER (P4222)
HANDLE (P4214)
Figure 2
VICE SCREW(P4205)
VICE GUIDE
SPRING (P4216)
BASE (P4201)
BENDING PLATE (P4209)
BRAMLEY No.2 ANGLE BENDER (MODEL 042 / AB2)
slot and tightening in the desired position. This is
useful for multiple bends of the same angle.
By loosening both the Clamp Vise and the Bending
Plate, the bent piece of material can then be
removed from the machine.
It is not recommended, or necessary, to use heat
during the bending process as this destroys the
grease lubricant in the swivel casting in which
case seizure may result and affect warranty on
the machine.
When bending softer materials such as aluminium
or copper for electrical bus-bars, it may be
preferable to remove the Clamp Pad (P4207 /
P6207) from the bender and, with a belt grinder or
similar, turn the sharp bending corner into a small
radius to avoid cracking of the material.
KNOB (P4208)
WASHER (P42C2)
SPLIT PIN
(P42C3)
VICE SCREW
HANDLE (P4206)
VICE GUIDE LONG (P4217)
HINGE PIN (P4203)
BENDING PLATE
PIN (P4210)
KNOB (P4208)
BENDING PLATE
SCREW (P4211)
BENDING PLATE
SCREW HANDLE (P4212)
M8X60 BOLT & NUT
(P42C4)
SWIVEL (P4202)
SWIVEL HEIGHT
ADJUSTER (P4218)